Nortec MH Series installation manual Revision Number Date Date Put Manual

Page 2

PROPRIETARY NOTICE

This document and the information disclosed herein are proprietary data of WALTER MEIER LTD. Neither this document nor the information contained herein shall be reproduced used, or disclosed to others without the written authorization of WALTER MEIER LTD., except to the extent required for installation or maintenance of recipient’s equipment. All references to the NORTEC name should be taken as referring to WALTER MEIER LTD.

LIABILITY NOTICE

WALTER MEIER LTD. does not accept any liability for installations of humidity equipment installed by unqualified personnel or the use of parts/components/equipment that are not authorized or approved by WALTER MEIER LTD.

COPYRIGHT NOTICE

Copyright 2008, WALTER MEIER LTD. All rights reserved.

RECORD OF REVISIONS

For each revision, put the revised pages in your manual and discard the superseded pages. Write the revision number and revision date, date put in manual, and the incorporator’s initials in the applicable columns on the Record of Revisions.

Revision Number

Revision

Date

Date Put

In Manual

By

Revision Number

Revision

Date

Date Put

In Manual

By

Image 2
Contents SeriesTM 2544831-ARevision Number Date Date Put Manual Table of Contents This page Intentionally Left Blank Introduction Safekeeping SafetyLimitation Copyright protectionFunction of the Display and Operating Elements DisplaySwitching the Control Unit on and OFF Remote Operating and Fault IndicationOverview and Operating of the Menu Menu OverviewExplanation of Configuration Settings Explanation of the Status Information Indication StatusInfo Page Clean Trg Info Page Box drying Info Page UV Module optionExplanation of Unit Information Path Main menu Info Unit StatusExplanation of Error History List Path Main menu Info Error HistoryConfiguration Factory setting English Unit SettingsLaunching the unit settings menu Select dialogue languageControl Settings Description of the SettingsFactory setting Options Setting the capacity limitationDescription of the Settings Factory settingSetting the Cleaning Mode Mhtc Reflow only Factory setting DrainConfiguring the cleaning trigger 1 Clean Trg 10-10 Configuring the humidification box drying Configuring the Humidifier Maintenance Interval Activating/deactivating the softstart functionPerforming remote relay tests Factory setting None Seconds Setting range 1...600 SecondsThis page Intentionally Left Blank Operational Functions Empties. The yellow LED flashes Carrying OUT Manual Draining / Pipe FlushingBriefly press the drain key . The drain/flush Yellow LED flashesResetting the Maintenance Indication Path Main menu User Password entry 8808 MaintenanceResetting the Hours Meter of the UV Lamp Troubleshooting Fault Indication Fault IndicationTroubleshooting 1.2.1 System Faults Unit Faults Tub the float is not open Maximum lifespan UV lamp reached 2008-12-03 Resetting the Error Indication Warranty Authorized Agent