Nortec MH Series installation manual Warranty

Page 39

WARRANTY

(1)WALTER MEIER INC. and/or WALTER MEIER LTD. (hereinafter collectively referred to as THE COMPANY), warrant for a period of two years after installation or 30 months from manufacturer’s ship date, whichever date is earlier, that THE COMPANY’s manufactured and assembled products, not otherwise expressly warranted (with the exception of the cylinder), are free from defects in material and workmanship. No warranty is made against corrosion, deterioration, or suitability of substituted materials used as a result of compliance with government regulations.

(2)THE COMPANY’s obligations and liabilities under this warranty are limited to furnishing replacement parts to the customer, F.O.B. THE COMPANY’s factory, providing the defective part(s) is returned freight prepaid by the customer. Parts used for repairs are warranted for the balance of the term of the warranty on the original humidifier or

90 days, whichever is longer.

(3)The warranties set forth herein are in lieu of all other warranties expressed or implied by law. No liability whatsoever shall be attached to THE COMPANY until said products have been paid for in full and then said liability shall be limited to the original purchase price for the product. Any further warranty must be in writing, signed by an officer of

THE COMPANY.

(4)THE COMPANY’s limited warranty on accessories, not of the companies manufacture, such as controls, humidistats, pumps, etc. is limited to the warranty of the original equipment manufacturer from date of original shipment of humidifier.

(5)THE COMPANY makes no warranty and assumes no liability unless the equipment is installed in strict accordance with a copy of the catalog and installation manual in effect at the date of purchase and by a contractor approved by THE COMPANY to install such equipment.

(6)THE COMPANY makes no warranty and assumes no liability whatsoever for consequential damage or damage resulting directly from misapplication, incorrect sizing or lack of proper maintenance of the equipment.

(7)THE COMPANY retains the right to change the design, specification and performance criteria of its products without notice or obligation.

Image 39
Contents 2544831-A SeriesTMRevision Number Date Date Put Manual Table of Contents This page Intentionally Left Blank Introduction Copyright protection SafetyLimitation SafekeepingDisplay Function of the Display and Operating ElementsRemote Operating and Fault Indication Switching the Control Unit on and OFFMenu Overview Overview and Operating of the MenuExplanation of the Status Information Indication Status Explanation of Configuration SettingsInfo Page Clean Trg Info Page UV Module option Info Page Box dryingPath Main menu Info Unit Status Explanation of Unit InformationPath Main menu Info Error History Explanation of Error History ListConfiguration Select dialogue language Unit SettingsLaunching the unit settings menu Factory setting EnglishDescription of the Settings Control SettingsFactory setting Setting the capacity limitationDescription of the Settings Factory setting OptionsFactory setting Drain Setting the Cleaning Mode Mhtc Reflow onlyConfiguring the cleaning trigger 1 Clean Trg 10-10 Configuring the humidification box drying Activating/deactivating the softstart function Configuring the Humidifier Maintenance IntervalPerforming remote relay tests Seconds Setting range 1...600 Seconds Factory setting NoneThis page Intentionally Left Blank Operational Functions Yellow LED flashes Carrying OUT Manual Draining / Pipe FlushingBriefly press the drain key . The drain/flush Empties. The yellow LED flashesPath Main menu User Password entry 8808 Maintenance Resetting the Maintenance IndicationResetting the Hours Meter of the UV Lamp Troubleshooting Fault Indication Fault IndicationTroubleshooting 1.2.1 System Faults Unit Faults Tub the float is not open Maximum lifespan UV lamp reached 2008-12-03 Resetting the Error Indication Warranty Authorized Agent