Integra DTR-7.2 Connecting speakers, Ideal speaker configuration, Speaker placement

Page 20
Connecting speakers

Connecting speakers

Before connecting the speakers, place them correctly by consulting the instruction manuals that came with them.

For surround playback, the configuration and placement of your speakers are very important.

For THX surround EX playback, we recommend that you use a THX speaker system that is certified by Lucasfilm Ltd.

Ideal speaker configuration

Front right and left speakers

Center speaker

Produces a rich sound image by serving as a sound source for the front right and left speakers and enhancing the sonic movement.

Surround right and left speakers

Adds three-dimensional sonic movement and produces environmental sound associated with the background and effect sound for each scene.

Surround back speaker

Required for enjoying THX Surround EX, DTS-ES Matrix 6.1, or DTS-ES Discrete 6.1 audio. For audio using surround back right and surround back left speakers, a separately-sold 2- channel power amplifier is required.

Lucasfilm/THX recommends the use of two Surround Back speakers to enjoy the full potential of THX Surround EX. An external stereo power amplifier will need to be used to power the two speakers from the Pre-Amp out terminals.

However, if you are unable to position two speakers in your listening environment, a single surround speaker can be used and the DTR-7.2 has an internal amplifier to power this speaker for your convenience.

Subwoofer

Produces powerful and heavy bass.

Minimum speaker configuration for surround sound playback

Front right and left speakers

Surround right and left speakers

The sound recorded for the center speaker and the subwoofer will be properly distributed to the front right and left speakers for optimized surround playback.

Speaker placement

Ideal speaker placement varies depending on the size of your room and the wall coverings. Here, only typical example of speaker placement and recommendations are shown.

In order to create the optimum conditions for the best sound quality, be sure to place all the speakers so that the greatest difference between the distances of each speaker to the listening position is less than 20 feet (6 meters).

Important points regarding speaker placement

Front left and right speakers and center speaker

Place these three speakers at the same height from the floor.

Place each speaker so that sound is aimed at the location of the listener’s ears when at the listening position.

Surround left and right speakers

Place these speakers so that their height is 3 feet (1 meter) higher than that of the listener’s ears.

Surround back speaker/Surround back left and right speakers

Place these speakers behind the listener so that the angle between each speaker and the listener is approximately 15 degrees.

Place these speakers so that their height is 3 feet (1 meter) higher than that of the listener’s ears.

Note:

For audio using surround back right and surround back left speakers, a separately-sold 2-channel power amplifier is required.

(Only one surround back

(Two surround back

speaker)

speakers)

10

10

15˚ 15˚

8

8

9

Subwoofer

A subwoofer is recommended for the highest bass effect.

(Only one surround back speaker)

 

 

1

 

2

3

4

5

6

 

 

7

 

 

10

 

 

 

8

 

(Two surround back speakers)

 

 

 

 

 

 

 

Layout with dipolar

 

 

Layout with monopolar

speakers

 

 

 

 

 

speakers

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1

 

 

 

 

 

 

 

 

1

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

2

 

3

 

4

 

 

5

 

2

 

3

 

4

5

 

 

 

 

 

 

 

 

 

 

6

7

6

7

10

 

 

10

 

 

 

8

 

 

9

 

 

 

 

8

 

9

 

 

1

TV or screen

 

 

 

8

Surround back left

2

Front left speaker

 

 

 

 

speaker or Surround back

3

Subwoofer

 

 

 

 

speaker (only one

4

Center speaker

 

 

 

 

surrround back speaker)

5

Front right speaker

9

Surround back right

6

Surround left speaker

 

speaker

 

 

 

7

Surround right speaker

10

Listening position

Most dipoles have an arrow on them to indicate their orientation towards the screen. So for the side dipoles, the arrows point forward. For the back dipoles, the arrows should point towards each other to achieve the correct acoustical phasing in the room.

20

Image 20
Contents Contents Before usingSetup and operation Remote controllerImportant Safeguards AVISPrecautions 4. PowerFor U.S. models Note to CATV system installer 1. Recording CopyrightContents Contents Features Supplied accessoriesAmplifier Features Audio/Video FeaturesUsing the remote controller Before using this unitInstalling the remote controller batteries Front panel display Front panel facilitiesFront panel Front panel facilities Remote controller Front panel facilitiesRemote controller Rear panel facilities DIGITAL INPUT/OUTPUT coaxial and opticalRear panel facilities PRE OUTCOMPONENT VIDEO INPUT/OUTPUT A-BUSREMOTE CONTROL Power on/ready functionPower off function Rear panel facilitiesRear panel facilities IR IN/OUTVIDEO IN/OUT MULTI CHANNEL INPUTConnections Connecting your audio componentsConnections Connecting your video components6. Connecting a video cassette recorder VIDEO Connections9.Connecting a television monitor or projector ConnectionsMONITOR OUT Digital outputSpeaker placement Connecting speakersIdeal speaker configuration Connecting speakers Connecting antennas Connecting the AM antenna cableConnecting the included antennas Assembling the AM loop antennaConnecting antennas Connecting an FM outdoor antennaConnecting an AM outdoor antenna Directional linkageConnecting the remote zone Zone 2 speakers When using the ZONE 2 OUT terminalsfrom connecting block other componentConnecting the power Setup menus Navigating through the Setup menuButton on remote controller Button on DTR-7.2Advanced Menu Setup menusBasic Menu Hardware Setup 0. Hardware Setup menuSpeaker Setup 1. Speaker Setup menuSpeaker Setup 1-2.Speaker Distance sub-menuSpeaker Setup 1-3.Level Calibration sub-menuSpeaker Setup 1-4.Bass Peak LevelBass Peak Level Manager* sub-menu a. Bass Peak Level LimiterInput Setup 2. Input Setup menuInput Setup 2-2.Multichannel Setup sub-menuInput Setup 2-3.Video Setup sub-menua. Video b. Component VideoInput Setup 2-5.Intelli Volume sub-menua. Intelli Volume 2-4.Character Input sub-menuInput Setup 2-6.Listening Mode Preset sub-menuInput source signal Analog/PCMInput Setup a. Analog/PCMInput Setup 2-7.12V Trigger Setup sub-menuAudio Adjust 3. Audio Adjust Setup menuAudio Adjust Audio Adjust 3-6.Mono SetupAudio Adjust 3-8.Surround SetupAudio Adjust Setting3-10. 3-11. 3-12. 3-13 ParameterPreference 4. Preference menuPreference 4-2.Headphones Level Setup sub-menu4-3.OSD Setup sub-menu 4-4.OSD Position sub-menuListening to a stereo radio station FM mode Listening to Radio BroadcastsTuning into a radio station Listening to Radio Broadcasts Presetting a radio stationSelecting a preset radio station Erasing a preset radio stationEnjoying music or videos with the DTR-7.2 Adjusting the bass and trebleListening with headphones Temporarily turning off the soundEnjoying music or videos with the DTR-7.2 Changing the listening modeSwitching the display Adjusting the brightness of the front displayUsing the sleep time remote controller only Enjoying music or videos with the DTR-7.2Enjoying the multichannel output Enjoying music or videos with the DTR-7.2Changing the audio mode Enjoying music in the remote zone Playing music using the buttons on the DTR-7.2Video Recording a source1.Press the CD input source button Using remote controller OverviewUsing remote controller Controlling an Integra/Onkyo CD playerUsing remote controller DVD MODE SETUP VOL MENU MUTING SUBTITLEControlling an Integra/Onkyo DVD player ON STDBYUsing remote controller Controlling an Integra/Onkyo MD recorderSAT, CABLE, VCR, and TV MODE buttons 1 to 9, 0, --/--- Numeric keysLearning a pre-programmingcode Learning a pre-programmingcodeLearning a pre-programmingcode SETTING NoSETTING No SETTING NoOperating your programmed remote controller DVD MODE DVD Player ModeSAT MODE Satellite Tuner Mode CABLE MODE Cable ModeTV MODE TV Mode Operating your programmed remote controllerVCR MODE VCR Mode Programming procedure Page Erasing the programmed command from one button ENTER3.Press and release the same button again ENTERUsing a Macro function What is a Macro function?Running a Direct Macro function Using a Macro functionProgramming the Direct Macro function Using a Macro function Erasing a macro from the MODE MACRO buttonMODE MACRO 2.Press the MODE MACRO button againUsing a Macro function Specifications REMOTE CONTROLLERAMPLIFIER SECTION All channelsTroubleshooting guide POWERSPEAKERS FM/AM TUNERTroubleshooting guide REMOTE CONTROLLERVIDEO and AUDIO OTHERMemo Memo Integra Division of ONKYO U.S.A. CORPORATION Integra Division of ONKYO CORPORATIONTel 072-831-8111Fax SN 29343210A