Integra DTR-7.2 Before using this unit, Installing the remote controller batteries

Page 7
Before using this unit

Before using this unit

Installing the remote controller batteries

1.Remove the battery compartment cover by pressing and sliding the cover.

2.Insert two AA (R6 or UM-3) batteries into the battery compartment. Carefully follow the polarity diagram (positive (+) and negative (–) symbols) inside the battery compartment.

3.After batteries are installed and seated correctly, replace the compartment cover.

1

2

3

Using the remote controller

Point the remote controller toward the remote control sensor. The Standby indicator lights up when the unit receives a signal from the remote controller.

Remote control sensor

DTR-7.2

Standby indicator

30˚

30˚

Approx. 16 feet (5 meters)

Notes:

Do not mix new batteries with old batteries or different kinds of batteries.

To avoid corrosion, remove the batteries if the remote controller is not to be used for a long time.

Remove dead batteries immediately to avoid damage from corrosion. If the remote controller does not operate smoothly, replace both the batteries at the same time.

Notes:

Place the unit away from strong light such as direct sunlight or inverted fluorescent light which can prevent proper operation of the remote controller.

Using another remote controller of the same type in the same room or using the unit near equipment which uses infrared rays may cause operational interference.

Do not put objects on the remote controller. Its buttons may be pressed by mistake and drain the batteries.

Make sure the audio rack doors do not have colored glass. Placing the unit behind such doors may prevent proper remote controller operation.

If there is any obstacle between the remote controller and the remote control sensor, the remote controller will not operate.

7

Image 7
Contents Remote controller ContentsBefore using Setup and operationAVIS Important Safeguards1. Recording Copyright Precautions4. Power For U.S. models Note to CATV system installerContents Contents Audio/Video Features FeaturesSupplied accessories Amplifier FeaturesInstalling the remote controller batteries Before using this unitUsing the remote controller Front panel Front panel facilitiesFront panel display Front panel facilities Front panel facilities Remote controllerRemote controller DIGITAL INPUT/OUTPUT coaxial and optical Rear panel facilitiesA-BUS Rear panel facilitiesPRE OUT COMPONENT VIDEO INPUT/OUTPUTRear panel facilities REMOTE CONTROLPower on/ready function Power off functionMULTI CHANNEL INPUT Rear panel facilitiesIR IN/OUT VIDEO IN/OUTConnecting your audio components ConnectionsConnecting your video components ConnectionsConnections 6. Connecting a video cassette recorder VIDEODigital output 9.Connecting a television monitor or projectorConnections MONITOR OUTIdeal speaker configuration Connecting speakersSpeaker placement Connecting speakers Assembling the AM loop antenna Connecting antennasConnecting the AM antenna cable Connecting the included antennasDirectional linkage Connecting antennasConnecting an FM outdoor antenna Connecting an AM outdoor antennaWhen using the ZONE 2 OUT terminals Connecting the remote zone Zone 2 speakersother component from connecting blockConnecting the power Button on DTR-7.2 Setup menusNavigating through the Setup menu Button on remote controllerBasic Menu Setup menusAdvanced Menu 0. Hardware Setup menu Hardware Setup1. Speaker Setup menu Speaker Setup1-2.Speaker Distance sub-menu Speaker Setup1-3.Level Calibration sub-menu Speaker Setupa. Bass Peak Level Limiter Speaker Setup1-4.Bass Peak Level Bass Peak Level Manager* sub-menu2. Input Setup menu Input Setup2-2.Multichannel Setup sub-menu Input Setupb. Component Video Input Setup2-3.Video Setup sub-menu a. Video2-4.Character Input sub-menu Input Setup2-5.Intelli Volume sub-menu a. Intelli VolumeAnalog/PCM Input Setup2-6.Listening Mode Preset sub-menu Input source signala. Analog/PCM Input Setup2-7.12V Trigger Setup sub-menu Input Setup3. Audio Adjust Setup menu Audio AdjustAudio Adjust 3-6.Mono Setup Audio Adjust3-8.Surround Setup Audio AdjustParameter Audio AdjustSetting 3-10. 3-11. 3-12. 3-134. Preference menu Preference4-4.OSD Position sub-menu Preference4-2.Headphones Level Setup sub-menu 4-3.OSD Setup sub-menuTuning into a radio station Listening to Radio BroadcastsListening to a stereo radio station FM mode Erasing a preset radio station Listening to Radio BroadcastsPresetting a radio station Selecting a preset radio stationTemporarily turning off the sound Enjoying music or videos with the DTR-7.2Adjusting the bass and treble Listening with headphonesChanging the listening mode Enjoying music or videos with the DTR-7.2Enjoying music or videos with the DTR-7.2 Switching the displayAdjusting the brightness of the front display Using the sleep time remote controller onlyChanging the audio mode Enjoying music or videos with the DTR-7.2Enjoying the multichannel output Playing music using the buttons on the DTR-7.2 Enjoying music in the remote zone1.Press the CD input source button Recording a sourceVideo Overview Using remote controllerControlling an Integra/Onkyo CD player Using remote controllerON STDBY Using remote controllerDVD MODE SETUP VOL MENU MUTING SUBTITLE Controlling an Integra/Onkyo DVD player1 to 9, 0, --/--- Numeric keys Using remote controllerControlling an Integra/Onkyo MD recorder SAT, CABLE, VCR, and TV MODE buttonsLearning a pre-programmingcode Learning a pre-programmingcodeSETTING No Learning a pre-programmingcodeSETTING No SETTING NoCABLE MODE Cable Mode Operating your programmed remote controllerDVD MODE DVD Player Mode SAT MODE Satellite Tuner ModeVCR MODE VCR Mode Operating your programmed remote controllerTV MODE TV Mode Programming procedure Page ENTER Erasing the programmed command from one buttonENTER 3.Press and release the same button againWhat is a Macro function? Using a Macro functionProgramming the Direct Macro function Using a Macro functionRunning a Direct Macro function 2.Press the MODE MACRO button again Using a Macro functionErasing a macro from the MODE MACRO button MODE MACROUsing a Macro function All channels SpecificationsREMOTE CONTROLLER AMPLIFIER SECTIONFM/AM TUNER Troubleshooting guidePOWER SPEAKERSOTHER Troubleshooting guideREMOTE CONTROLLER VIDEO and AUDIOMemo Memo SN 29343210A Integra Division of ONKYO U.S.A. CORPORATIONIntegra Division of ONKYO CORPORATION Tel 072-831-8111Fax