Integra instruction manual Enjoying music or videos with the DTR-7.2, Switching the display

Remote controller

Enjoying music or videos with the DTR-7.2

Display	Dimmer			SLEEP
				RCVR
Display	Dimmer		Rec Out Zone 2Off	Master Volume
Standby/On					TEST
			Setup	CH SEL
		Tuning

Standby

Power

On Off

Upsampling

Phones

Audio

Selector

Enter

Return

Preset

Direct

Stereo

Surround

THX

DSP

FM Mode

Memory

A-FORM Listening Mode Memory

Clear

Zone 2 (GRN )

Video 5/Video Cam Input

Rec ( RED )

DVD

Video 1

Video 2

Video 3

Video 4

Video 5

Tape

FM

AM

Phono

CD

LEVEL/

VCR 1 VCR 2 Digital S Video Video L Audio R

Input source buttons	DISPLAY	DIMMER
		HOME THEATER CONTROLLER
		RC-461M

Switching the display

While listening to or watching an input source, you can display the information regarding the type of source and signal being input by pressing the Display button on the DTR-7.2 or the DISPLAY button on the remote controller.

DTR-7.2	Remote controller
Display

When an input source other than FM or AM is selected:

Input + volume

Program format*

Input + Listening mode or Multi Ch

*If the input signal does not have a program format, then this will be skipped.

When FM or AM is selected as the input source:

FM/AM frequency +	ch
Preset no.

FM/AM +

Listening mode

Adjusting the brightness of the front display

You can adjust the brightness of the front display of the DTR-7.2 with DIMMER button on the remote controller or the Dimmer button on the DTR-7.2 front panel.

DTR-7.2	Remote controller
Dimmer

Using the sleep time (remote controller only)

The SLEEP button enables you to set the DTR-7.2 to turn off automatically after a specified time period. If you press it once, the DTR-7.2 will turn off after 90 minutes. Each time it is pressed thereafter, the remaining time until the DTR-7.2 turns off decreases by 10 minutes. While, the sleep function is enabled, you can press the SLEEP button to see how much time is left. To cancel the sleep function, press the SLEEP button when the time displayed is less than 10 minutes.

If you are using the remote zone (Zone 2), it will turn off at the same time as the main zone. If you want to set the sleep function for Zone 2 only, set the sleep function with main zone turned on and then put the main zone into the standby state.

Temporarily changing the speaker output levels

To change the individual speaker volumes temporarily, follow the procedure given below. Each channel can be set between –12 to +12 decibels. Note that the calibration settings will return to the original settings when the DTR-7.2 is put in standby.

1. Press the RCVR MODE button.

2. Press the CH SEL button and select the desired speaker.

3. Press the LEVEL or button to adjust the volume level.

Notes:

•You cannot select a speaker if the Speaker Config sub-menu of the Speaker Setup is set to No or None.

•If the speaker level is set to +1 dB or higher, the maximum level indicated on the display will change if you raise the volume level.

•When you press the TEST button after you set the level, the current level will be used as the value set via the test tone.

52