Integra DTR-7.6/6.6 instruction manual Controlling Other Components, Entering Remote Control Codes

DTR-7.6,6.6.book Page 84 Monday, September 26, 2005 1:40 PM

Controlling Other Components

You can control your other components, including those made by other manufacturers, with the remote controller. This section explains how to:

•Enter the remote control code for a component that you want to control (e.g., DVD, TV, VCR).

•Learn commands directly from another component’s remote controller (see page 87).

•Program the Macro buttons to perform a sequence of up to eight actions (see page 88).

Entering Remote Control Codes

To control another component, you must first enter the appropriate remote control code to a Remote Mode but- ton. You’ll need to enter a code for each component that you want to control.

Remote

Standby indicator

TV I

Number buttons

Receiver

Remote

Mode

1	Look up the appropriate remote
	control code in the separate
	Remote Control Codes list.
	The codes are organized by category.
	The Remote Mode buttons shown in the
	Remote Control Codes list may differ
	slightly to those on the actual remote
	controller. Operation is unaffected.

2	While holding down the Remote
	Mode button to which you want
	to enter the code, press the
	[Standby] button.
	The Remote indicator lights up.

3	Within 30 seconds, use the num-
	ber buttons to enter the 4-digit
	remote control code.
	The Remote indicator flashes twice.

4	Press the Remote Mode button
	again to select the remote con-
	troller mode, point the remote
	controller at the component, and
	check the operation.
	If the remote controller doesn’t work as
	expected, and several remote codes are
	listed, try each one in turn and use the
	one that works best.

Notes:

•Remote control codes cannot be entered for the [Receiver] and [HDD] Remote Mode buttons.

•The remote control codes provided are correct at the time of printing, but are subject to change.

•The HDD remote mode can only be used with the Onkyo DS-A1 Remote Interactive Dock at this time.

•The [DVD] and [CD] Remote Mode buttons are preprogrammed for use with Integra DVD players and CD players respectively.

*To control another manufacturer’s CD recorder or MD recorder, enter the appropriate control code to the [CD] Remote Mode button.

84