Integra DTR-7.6/6.6 Controlling Other Components, Resetting the Remote Controller

DTR-7.6,6.6.book Page 85 Monday, September 26, 2005 1:40 PM

Controlling Other Components—Continued

Remote Control Codes for Integra Components Connected via

Integra components that are connected via are con- trolled by pointing the remote controller at the AV receiver, not the component. This allows you to control components that are out of view, in a rack, for example.

1	Make sure the Integra component is con-
	nected with an		cable and an analog
	audio cable (RCA).
	See page 33 for details.
2	Enter the appropriate remote control code
	for the Remote Mode button.
	•	[DVD] Remote Mode button
		5002: Integra DVD player with
	•	[CD] Remote Mode button
		6002: Integra CD player with
	•	[MD] Remote Mode button
		6008: Integra MD recorder with
	•	[CDR] Remote Mode button
		6006: Integra CD recorder with
	See the previous page for how to enter remote
	control codes.
3	Press the Remote Mode button, point the
	remote controller at the AV receiver, and

operate the component.

If you want to control an Integra component by pointing the remote controller directly at it, or you want to control

an Integra component that’s not connected via , use the following remote control codes:

• [DVD] Remote Mode button

5001: Integra DVD player without (default)

•	[CD] Remote Mode button
	6001: Integra CD player without	(default)
•	[MD] Remote Mode button
	6007: Integra MD recorder without
•	[CDR] Remote Mode button
	6005: Integra CD recorder without

Note:

If you connect an -capable Integra MiniDisc or CD recorder to the TAPE IN/OUT jacks, for remote opera- tion to work properly, you must set the input display to MD or CDR (see page 44).

Resetting the Remote Mode Buttons

You can reset a Remote Mode button to its default remote control code.

1	While holding down the Remote
	Mode button that you want to
	reset, press the TV [	] button.

The Remote indicator flashes three times.

2	Press the Remote Mode button
	again.
	The Remote indicator flashes twice,
	indicating that the button has been
	reset.
	The [DVD] and [CD] Remote Mode
	buttons are preprogrammed with
	remote control codes for controlling
	Integra DVD players and CD players
	respectively. When these buttons are
	reset, the preprogrammed code is
	restored.

Resetting the Remote Controller

You can reset the remote controller to its default settings.

1 While holding down the

[Receiver] Remote Mode button, press the [Standby] button.

The Remote indicator flashes five times.

2	Press the [Receiver] Remote
	Mode button again.
	The Remote indicator flashes twice,
	indicating that the remote controller
	has been reset.

85