Windsor CLP12IB, CLP12IE, CLP12IA, CLP12IS manual Operations, Incorrect

Page 12

OPERATIONS

1/8in (3mm)

CORRECT

INCORRECT

STEP

Remove electrical cord and literature from recovery tank. Fill solution tank (see filling instructions).

Plug cord into grounded outlet. Note: Be sure dome is seated on recovery tank, and float shut-off is installed correctly.

Adjust brush to proper setting. Note: For good operation the brush must skim the carpet. If circuit breaker trips raise brush to prevent damage to motor or carpet.

SOLUTION BRUSH VACUUM

INTONON

CONT

STEP

Turn on brush and vacuum motor switches (“ON”=“I”). Turn on solution switch for continuous spray or set switch to intermittent to allow use of trigger switches.

3-5ENG

86038280 04/04/07

Image 12

Contents Carpet Extractor Machine Data LOG Date of Purchase Serial Number Sales Representative #Table of Contents HOW to USE this Manual Important Safety Instructions Connect to a properly grounded outletFor Safety When Servicing MachineHazard Intensity Level Hazard Intensity LevelGrounding Instructions This Product is for Commercial USE OnlyElectrical Extension CordsTechnical Specifications DIMENSION/CAPACITYVacuum Motor Switch. Turns on vacuum motor CONTROLS/COMPONENT LocationsElectrical Cord 3ENG 4ENG Operations Incorrect6ENG Filling Operations Filling the ClipperChemicals Cleaning Procedure OFF9ENG 10ENG Accessory Tool Usage Maintenance Turn off all switches and unplug machineRemove recovery tank Remove the 2 screws that fasten the solutionSolution Pump Replacement Pump Replacement Parts for Shurflo 100 psi 86026400 PRV noBelt Replacement Periodic Maintenance Daily / Regular MaintenanceTroubleshooting Chart Problem Cause Solution5ENG