Windsor CLP12IA, CLP12IB, CLP12IE, CLP12IS manual Troubleshooting Chart, Problem Cause Solution

TROUBLESHOOTING CHART

PROBLEM	CAUSE		SOLUTION
No Power, Nothing	1.	Is the cord plugged in?	1.	Plug in cord.
	2.	Circuit breaker tripped in building.	2.	Reset breaker
Runs	3.	Faulty switch.	3.	Call for service.
	4.	Faulty power cord or pigtail.	4.	Call for service.
	1.	Vacuum circuit breaker tripped.	1.	Reset breaker
Vacuum Motor Will Not	2.	Faulty main vacuum switch.	2.	Call for service.
Run	3.	Loose wiring.	3.	Call for service.
	4.	Faulty vac motor.	4.	Call for service.
	1.	Debris lodged in vac shoe.	1.	Remove debris from vac shoe.
Vacuum Motor Runs	2.	Dome gasket defective or missing.
			2.	Replace as necessary.
	3.	Vacuum hose cracked or hose cuff
But			3.	Replace or repair as necessary.
		loose.
Suction Is Poor			4.	Turn off vac motor. Drain and rinse
	4.	Recovery tank full / float ball stuck in
				recovery tank.
		the up position.
	1.	Main pump switch off.	1.	Turn on.
Poor Or No Water Flow	2.	Jets clogged or missing.	2.	Clean using a vinegar /water
				solution or replace.
(Carpet Is Streaky)	3.	Solution filter clogged.	3.	Drain solution tank and clean
				solution filter.
	4.	Faulty solenoid.	4.	Call for service.
	1.	Brush switch off.	1.	Turn on brush switch.
Brush Does Not Spin	2.	Brush circuit breaker tripped	2.	Reset circuit breaker.
	3.	Brush belt broken.	3.	Replace as necessary.
	4.	Faulty brush motor.	4.	Call for service.

4-4ENG 86038280 04/04/07