1 | 2 |
CLEANING PROCEDURE
1.This machine can be operated in either direction. For smaller areas operate the machine by pulling rearward.
2.For larger unobstructed areas, flip the handle and use the machine’s brush assisted propelling motion.
STEP Start at wall closest to power outlet. For
1small areas, pull straight back without pushing down on handle.
1ft.
(30cm)
OFF
STEP
2
Release intermittent trigger switches or turn off continuous setting on solution switch approximately 1 foot before ending cleaning pass.
1in.
(25mm)
STEP
3
Push down on handle to raise vacuum shoe and brush before moving to the next cleaning pass. Overlap brush contact area a minimum of 1inch on the right (close cleaning) side of machine. Overlap a minimum of 2inches on the left (drive belt) side of machine. Refer to illustration for the left and right side of the machine.
86038280 04/04/07 |