Windsor CLP12IA, CLP12IB, CLP12IE manual Hazard Intensity Level, For Safety, When Servicing Machine

Page 6

HAZARD INTENSITY LEVEL

The following symbols are used throughout this guide as indicated in their descriptions:

HAZARD INTENSITY LEVEL

There are three levels of hazard intensity identified by signal words -WARNINGand CAUTION and FOR SAFETY. The level of hazard intensity is determined by the following definitions:

!

WARNING - Hazards or unsafe practices which COULD result in severe personal injury or death.

!

CAUTION - Hazards or unsafe practices which could result in minor personal injury or product or property damage.

FOR SAFETY: To Identify actions which must be followed for safe operation of equipment.

Report machine damage or faulty operation immediately. Do not use the machine if it is not in proper operating condition. Following is information that signals some potentially dangerous conditions to the operator or the equipment. Read this information carefully. Know when these conditions can exist. Locate all safety devices on the machine. Please take the necessary steps to train the machine operating personnel.

FOR SAFETY:

DO NOT OPERATE MACHINE:

Unless Trained and Authorized.

Unless Operation Guide is Read and understood.

In Flammable or Explosive areas.

In areas with possible falling objects.

WHEN SERVICING MACHINE:

Avoid moving parts. Do not wear loose clothing; jackets, shirts, or sleeves when working on the machine. Use Windsor approved replacement parts.

.

2-2ENG

86038280 04/04/07

Image 6
Contents Carpet Extractor Machine Data LOG Date of Purchase Serial Number Sales Representative #Table of Contents HOW to USE this Manual Important Safety Instructions Connect to a properly grounded outletHazard Intensity Level For SafetyWhen Servicing Machine Hazard Intensity LevelElectrical Grounding InstructionsThis Product is for Commercial USE Only Extension CordsTechnical Specifications DIMENSION/CAPACITYVacuum Motor Switch. Turns on vacuum motor CONTROLS/COMPONENT LocationsElectrical Cord 3ENG 4ENG Operations Incorrect6ENG Filling Operations Filling the ClipperChemicals Cleaning Procedure OFF9ENG 10ENG Accessory Tool Usage Remove recovery tank MaintenanceTurn off all switches and unplug machine Remove the 2 screws that fasten the solutionSolution Pump Replacement Pump Replacement Parts for Shurflo 100 psi 86026400 PRV noBelt Replacement Periodic Maintenance Daily / Regular MaintenanceTroubleshooting Chart Problem Cause Solution5ENG