Wayne-Dalton series 3000 user manual Once a Month, Twice a Year, Once a Year

Page 27

MAINTENANCE OF YOUR OPENER SYSTEM

Test door opener monthly. The garage door MUST reverse on contact with a 1 inch high solid test ob- ject on the floor. If adjusting either the force or the limit of travel, retest the door opener. Failure to ad- just the opener properly may cause severe injury of death.

KEEP GARAGE DOORS PROPERLY BALANCED. See owner’s manual. An improperly balanced door could cause severe injury or death. Have a qualified service person make repairs to cables, spring as- semblies and other hardware.

Once a Month:

1.Manually operate door, if unbalanced or binding, call a professional garage door service person.

2.Check to be sure door opens and closes fully. Adjust Limits and/or Force, (see pages 18, 19 and 21).

3.Perform safety reverse tests (Step 27 and 29). Make any necessary adjustments.

Twice a Year:

Check chain tension. If chain rests on bottom of rail, adjust tension by turning the two chain adjusting nuts at the end of the rails (opposite the power head end) clockwise. Make sure to adjust both nuts equal amounts and until chain is approximately 1/2” above rails when measured in the middle of the rails.

Once a Year:

1.Lubricate door rollers, bearings and hinges. (Refer to door owner’s manual for maintenance information).

2.Check batteries in Transmitters, Wireless Wall Station, Wireless Keyless Entry and Wireless Infrared Safety Sen- sors (if included). When replacing batteries always use new batteries; never mix old and new batteries. Never mix different types of batteries (see pages 14, 15, 17 and 21). Alkaline or Lithium batteries are recommended for longer life. Dispose of used batteries properly.

27

Image 27
Contents Owner Installation Important Installation Instructions Page Features Important PRE-ASSEMBLY Check Positioning and Installing Front Wall Bracket Attaching Motor Power Head Unit to RailAttach Unit to Front Wall Bracket Positioning the Motor End of OperatorMounting Motor End of Opener Installing Light Installing Wired Wall Station if includedMounting Door Bracket Install Entrapment Warning Label Installing Deluxe Wireless Wall Station if includedInstall Wireless Infrared Safety Sensor Install Wireless Infrared Safety Sensor BracketInstall Wired Infrared Safety Sensor Wall Mounting Brackets Connecting Wired Infrared Safety Sensor to Opener Install Wiring for Wired Infrared Safety SensorConnecting Electrical Power Mount Wired Infrared Safety SensorsChanging Wireless Wall Station Code Wireless Wall Station Security Code Change and ProgrammingAlignment of the Wireless Infrared Safety Sensors Transmitter Security Code Change and Programming Alignment of the Wired Infrared Safety SensorsTwo Button Transmitter Security Code Change and Programming Programming Transmitter to Power Head UnitSetting Trolley Close Posi- tion Connecting Door Arm to DoorUpper Door Arm Positioning Setting Door Opening Travel IMPORTANT! Test Contact Obstruction Sensing FeatureProgramming Wireless Keyless Entry If Included Infrared Safety Sensor Obstruction TestAdjustment # 1 Opening and Closing Force Installing Wireless Keyless Entry If IncludedAdjustment # 3 Positive Mechanical Door Lock Adjustment # 2 Contact Obstruction Sensing Closing DirectionImportant Safety Instructions Operation of Your Opener HOW to Operate the Wireless Keyless Entry if IncludedOpener Power Head Controls HOW to Operate the Wireless Wall Station If IncludedPage Once a Month Twice a YearOnce a Year Trouble Shooting Section Parts Breakdown Rail Assembly All Models Description Per Unit # Per Quantum Accessories Cut Template to Aid in Keyless Entry Installation See Step Limited Lifetime Warranty