Dcenter GEQ, Elfe Level, Fdynamic Range, Gaudio SET

SET MENU

■Center graphic equalizer D)CENTER GEQ

Use this feature to adjust the built-in 5-band graphic equalizer for the center channel so that the tonal quality of the center speaker matches that of the front speakers. You can make adjustments listening to the currently selected source component or a test tone.

You can adjust 5 frequency bands: 100Hz, 300Hz, 1kHz, 3kHz, 10kHz

Choices: –6 to +6 dB

D)CENTER GEQ

. )OFF

•Select ON to output test tones from the front left and center speakers, and adjust the tonal quality of the center speaker.

•Select OFF to stop the test tone and output the currently selected source component.

•Press u / d to select a frequency band.

•Press j / i to adjust the selected frequency band.

■Low-frequency effect level E)LFE LEVEL

Use to adjust the output level of the LFE (low-frequency effect) channel according to the capacity of your subwoofer or headphones. The LFE channel carries low- frequency special effects which are only added to certain scenes. This setting is effective only when this unit decodes Dolby Digital or DTS signals.

Choices: –20 to 0 dB

E)LFE LEVEL

. ;;;;;;0dB

;;;;0dB

Speaker SPEAKER

Select to adjust the speaker LFE level.

Headphone HEADPHONE

Select to adjust the headphone LFE level.

Note

Depending on the settings of “LFE LEVEL”, some signals may not be output from the SUB WOOFER OUTPUT jack.

■Dynamic range F)DYNAMIC RANGE

Use to select the amount of dynamic range compression to be applied to your speakers or headphones. This setting is effective only when the unit is decoding Dolby Digital and DTS signals.

Choices: MIN (minimum), STD (standard), MAX (maximum)

F)DYNAMIC RANGE

.)MAX )MAX

Speaker SP

Select to adjust the speaker compression.

Headphone HP

Select to adjust the headphone compression.

•Select MIN if you regularly listen at low volume levels.

•Select STD for general use.

•Select MAX to preserve the greatest amount of dynamic range.

■Audio set G)AUDIO SET

Use to customize this units overall audio settings.

G)AUDIO SET

.;;MUTE ;;0ms

;;;OFF

Audio mute AUDIO MUTE

Use to adjust how much the mute function reduces the output volume.

Choices: MUTE, –20 dB

•Select MUTE to completely halt all output of sound.

•Select –20 dB to reduce the current volume by 20 dB.

Audio delay AUDIO DELAY

Use to delay the sound output and synchronize it with the video image. This may be necessary when using certain LCD monitors or projectors.

Choices: 0 to 160 ms