ION DSP-AX750SE Connecting the power supply cord, Connecting the AC power cord, Memory back-up

CONNECTIONS

Connecting the power supply cord

■Connecting the AC power cord

Plug the power cord into an AC wall outlet.

■AC OUTLET(S) (SWITCHED)

U.K. and Australia models	.............................. 1 OUTLET
Korea model	None
Other models	2 OUTLETS

Use these outlets to connect the power cords from your other components to this unit. Power to the AC OUTLET(S) is controlled by this unit’s STANDBY/ON (or SYSTEM POWER and STANDBY). The outlet(s) supply power to any connected component whenever this unit is turned on. The maximum power (total power consumption of components) that can be connected to the AC OUTLET(S) is:

China, Asia and General models	.............................. 50 W
Korea model	N/A
Other models	100 W

■VOLTAGE SELECTOR

(Asia and General models only)

The VOLTAGE SELECTOR on the rear panel of this unit must be set for your local main voltage BEFORE plugging

into the AC main supply. Voltages are:
Asia model	220/230-240	V AC, 50/60 Hz
General model	110/120/220/230-240	V AC, 50/60 Hz

■Memory back-up

The memory back-up circuit prevents the stored data from being lost even if this unit is in the standby mode. However if the power cord is disconnected from the AC wall outlet, or the power supply is cut for more than one week, the stored data will be lost.

PREPARATION

VOLTAGE SELECTOR

VOLTAGE

SELECTOR

(Asia and General models)

English

23