Heat & Glo LifeStyle COSMO-I35, COSMO-I30 owner manual Service Parts List, At Depot

Page 36

C. Service Parts List				COSMO-I30
IMPORTANT: THIS IS DATED INFORMATION. When requesting service or replacement
						Stocked
parts for your appliance please provide model number and serial number. All parts listed						Stocked
in this manual may be ordered from an authorized dealer.						at Depot
ITEM	DESCRIPTION	COMMENTS	PART NUMBER
1	Termination Plate Assembly		2206-012
	Flex Pipe Handle		438-351
	Gasket		2206-401
2	Burner Assembly		2203-007			Y
3	Burner Leg		2203-103
4	Base Pan		2239-100
5	On/Off Rheostat		2206-800			Y
6	Glass Door Assembly		GLA-2206			Y
7	Rheostat Knob		100-512			Y
8	Control Panel		2205-129
9	Blower		GFK-210
10	Wire Assembly		2206-068			Y
11	Power cord Assembly		2201-017			Y


	Gasket Assembly		2206-080
	Gems, Black	Qyt 2 req	MEDIA-BK-GEMS
	Glass Latch Assembly, Bottom	Qty 2 req	2155-045			Y
	Glass Latch Assembly, Top	Qty 2 req	339-121A			Y
	Glass Refractory, Back		2239-200
	Glass Refractory, Left		2239-201
	Glass Refractory, Right		2239-202
	Jumper wire		2187-198			Y
	Remote Wire Assembly		2103-013			Y
	Touch Up Paint		TUP-GBK-12

	Conversion Kit NG	NGK-COSMOI30	Y
	Conversion Kit LP	LPK-COSMOI30	Y
	Pilot Oriﬁce NG	2098-520	Y
	Pilot Oriﬁce LP	2098-512	Y
	Regulator NG	NGK-DXV-50	Y
	Regulator LP	LPK-DXV-50	Y

Additional service part numbers appear on following page.

36	Heat & Glo • Cosmo-I30, Cosmo-I35 • 2239-900 Rev. H • 1/11

Image 36

Contents

Models Cosmo-I30 Cosmo-I35 What to do if you smell gasCongratulations Homeowner Reference InformationTable of Contents User GuideLimited Lifetime Warranty Limited Lifetime Warranty Listing and Code Approvals Gas Fireplace Safety Operating Instructions User GuideYour Fireplace Fixed Glass Assembly Remote Controls, Wall Controls and Wall SwitchesIPI Battery Tray/Battery Installation Clear SpaceModule Reset Control Module OperationBefore Lighting Fireplace Lighting Instructions IPI Final inspection byFrequently Asked Questions After Appliance is LitMaintenance and Service Maintenance Tasks-HomeownerGlass Cleaning Remote ControlMaintenance Tasks-Service Technician Gasket Seal and Glass Assembly InspectionVenting FireboxBurner Ignition and Operation IPI Pilot Flame PatternsGetting Started Typical Appliance SystemDesign and Installation Considerations Tools and Supplies NeededInspect Appliance and Components Fireplace Size Requirements Minimum Fireplace OpeningMantel and Wall Projections Side ViewTermination Locations Vent Termination Minimum ClearancesInstallation Preparation Installing Vent Pipe and Appliance Connecting Vent PipeVent Limits Venting ComponentsLocation of AUX300 for Remote Control Blower Function Placing, Securing and Leveling the Appli- anceInstalling Adaptor and Termination Cap MasonryFactory Built Wood Burning Damper Flashing Kit OptionalGas Information Fuel ConversionGas Pressure Gas ConnectionWiring Requirements IntelliFire Plus Ignition System WiringON/OFF Switch Electrical InformationOptional Accessories Requirements BRN To Valve Bracket BLK Ground RE DFan Wiring with Remote See .H for control module operation instructionsFinishing Clearances to Mantels or other Combustibles above ApplianceAppliance Setup Air Shutter Setting Air Shutter SettingsTroubleshooting Symptom Possible Cause Corrective ActionIntelliFire Plus Ignition System To remove any contaminants that may have accumulated on ﬂame Appliance Dimension Diagram Reference MaterialsVent Kits Components Direct Vent Flex Liner KitsService Parts Part number list on followingModern Metal Insert, IPI Service Parts List At DepotCOSMO-I35 COSMO-I35 StockedCOSMO-I30, COSMO-I35 Contact Information