3.1REMOVAL OF COVERS FOR SERVICING
A.Control Compartment Grille
•Rotate the bottom grille down to access the gas controls.
B.Trim door and Glass Door
•Lift the front trim door up and out away from the appliance side surrounds. Replace the door when servicing is complete.
•Note carefully how the glass assembly is held in place. Release the two spring latches at the bot- tom of the glass door. Next, remove wing nuts from the top of the glass door. Carefully lift the glass up and out away from the appliance. See Figure 31.
3.2REMOVAL OF COMPONENTS FOR SERVICE
1. BURNER
•Remove the logs and grate.
•Remove the top refractory brackets and carefully re- move the side refractories.
•Remove the bottom refractory.
•Unscrew the brackets at both ends of the burner and slide the burner away from the burner orifice.
2. PILOTASSEMBLY/IGNITION SYSTEM
•Remove the log set/log grate/refractory assembly.
WING NUT
GLASS ASSEMBLY
TENSION SPRING
LATCH
LATCH
BRACKET
FIGURE 31
•Disconnect the gas supply tube from the underside of the pilot burner.
•Disconnect the electrode wire from the piezo ignitor (found adjacent to the gas control valve).
•Disconnect the attachment nut from the underside of the thermopile. The thermopile can then be sepa- rated from the pilot bracket.
•Unscrew the pilot assembly bracket and remove. NOTE: When removing the pilot assembly, carefully pull the electrode wire up through the grommeted hole in the base pan.
3.3 PARTS REPLACEMENT
1. FAN/SWITCHES
•Unplug the fan wires from the junction box wires by pulling the male and female connectors apart and slide the fan out the front of the lower controls com- partment.
•Disconnect the wires from the fan speed control switch, pull off the knob, and remove the nut holding the speed control to the bracket.
•Disconnect the wires from the fan temperature sen- sor switch and remove the nut holding the switch bracket onto the side of the firebox.
2. GLASS PANEL
•To replace the glass door, locate the 4 top holes over the bolts above the opening, push glass against the unit and attach 2 lower tension springs. Hand tighten wing nuts into top 4 bolts.
NOTE: WING NUTS THAT SECURE THE GLASS ONLY NEED TO BE HAND TIGHTENED TO GIVE A SNUG FIT FOR PROPER GASKET SEAL. OVER- TIGHTENING MAY RESULT IN DAMAGED GLASS.
3. OVERHEAT SWITCH
•Remove the two screws holding the switch to the top left front of the sheetmetal surround.
•Disconnect the wire from the switch and remove the switch.
3.4ADJUSTMENTS AND REPLACEMENT PARTS
Adjustments and replacement parts for this appliance should only be done by a qualified service person. A wiring diagram for the appliance is shown in SECTION
2.0OPERATING INSTRUCTIONS. A replacement part table is shown in SECTION 4.0 of this manual.
27