Heatiator CL36D owner manual C. Check Firebox Refractory, D. Inspect Grate, E. Glass Cleaning

Page 12

C. Check Firebox Refractory

Frequency: After each ash removal

By: Homeowner

Warning! Risk of Fire! Inspect fireplace refractory. Crumbling, deteriorated refractory can allow overheating of surrounding materials.

Expansion and contraction will cause minor cracking of the refractory. This is normal. The refractory will require periodic replacement depending on use.

The panels should be replaced if

Cracks exceed ¼ inch (6 mm) in width,

Metal is exposed behind the refractory,

Large pieces of refractory fall out.

D. Inspect Grate

Frequency: After each ash removal

By: Homeowner

Inspect grate for:

Warping or sagging 1-1/2 in. (38 mm) or more

Broken welds

Burn-through of grate bars

For safe operation, replace only with an approved grate from Hearth & Homes Technologies Inc.

E. Glass Cleaning

Frequency: As desired

By: Homeowner

CaUTION! Handle glass assembly with care. Glass is breakable.

Avoid striking, scratching or slamming glass

Avoid abrasive cleaners

Do not clean glass while it is hot

Clean glass with a non-abrasive commercially available cleaner or ashes:

Light deposits

-Use household glass cleaner

Heavy deposits

-Use wood ash on damp cloth or,

-Use commercial fireplace glass cleaner (consult with your dealer)

12

Heatilator • CL36D, CR36D • 12538 • Rev Z 7/12

Image 12
Contents Wood Burning Fireplace Owner’s ManualModels CL36D CR36D Congratulations Homeowner Reference InformationListing Label Information/Location FIREPLACE NOTable of Contents Installer GuideSafety Alert Key User GuideLimited Warranty Hearth & Home Technologies Inc LIMITED LIFETIME WARRANTYWARRANTY COVERAGE WARRANTY PERIODWARRANTY CONDITIONS WARRANTY EXCLUSIONSThis warranty is void if LIMITATIONS OF LIABILITY1Listing and Code Approvals A. Appliance CertificationB. Non-CombustibleMaterials C. Combustible MaterialsUser Guide 2Operating InstructionsA. Your Fireplace Hot glass will cause burnsB. Seasoned Wood C. Starting a FireD. Grate E. FirescreenH. Glass Doors I. Outside Air optionalJ. Vented Gas Log Sets & Gas Log Lighters K. Optional ComponentsM. Wood Fuel Hardwood vs SoftwoodMoisture Seasoned Wood3Maintenance and Service B. Chimney Inspection/CleaningA. Disposal of Ashes Creosote - Formation and Need for RemovalE. Glass Cleaning C. Check Firebox RefractoryD. Inspect Grate Frequency: As desired4Troubleshooting Guide Start Fire ProblemsSolution Possible CauseInstaller Guide 5Getting StartedA. Typical Fireplace System •Illustrations/diagrams are not drawn to scaleB. Design and Installation Considerations C. DraftD. Negative Pressure E. Locating Fireplace & Chimney F. Tools and Supplies Needed G. Fireplace System RequirementsH. Inspect Fireplace and Components 6Framing & Clearances A. Select Fireplace LocationB. Clearances Heatilator • CL36D, CR36D • 12538 • Rev Z 7/12C. Sidewalls/Surrounds 20 in39 deg 50 degD. Frame the Fireplace 7Installation of Fireplace A. Things to ConsiderB. Position the Fireplace C. Place Protective Metal Hearth StripsNote: Chimney air kit not shown, but required inCanada Heatilator • CL36D, CR36D • 12538 • Rev Z 7/12E. Install Outside Air Kit 8Chimney Assembly A. Chimney Requirements TableB. Using Offsets/Returns TableExample D. Install Chimney Air Kit E. Install Ceiling FirestopsC. Assemble Chimney Sections F. Install Attic Insulation Shield H. Complete Installation I. Install FlashingG. Cut out Hole in Roof J. Chimney Termination Requirements 9Chase Installations A. Construct the ChaseB. Install Fireplace & Chimney D. Install Termination CapC. Install Chase Top •Warning! Risk of Fire! The minimum overlap of•TR342 Round Telescoping Termination Cap •TS345/TS345P Square Termination Cap•ST375 Square Termination Cap •TCT375 Terra Cotta Cap10 Shrouds A. Radiation ShieldB. Field Constructed Shrouds Figure 10.4 Roofed Style Shroud Dimensions Mailbox Style Shroud radiation shield requiredRoofed Style Shroud radiation shield required Heatilator CL36D, CR36D 12538 Rev Z 7/1211 Finishing A. Non-combustibleMaterialsB. Combustible Materials C. Hearth ExtensionD. Finishing Material Warning! Risk of FireE. Combustible Mantel MantelSidewalls/Surrounds 12 Accessories A. Gas Log/Lighter ProvisionB. Wood Burning Inserts Gas Code, ANSI Z223.1A. Fireplace Dimensions 13 Reference MaterialsB. Optional Components C. Chimney Components Catalog #14-1/2in 368 mmHeatilator • CL36D, CR36D • 12538 • Rev Z 7/12 D. Service Parts CL36DStocked at DepotD. Service Parts continued CR36DStocked at Depot– NOTES – E. Contact InformationDO NOT DISCARD THIS MANUAL DO DISCARDNOT
Related manuals
Manual 48 pages 11.28 Kb