EP1, EP2, EP3, EP4, A5.1 | Fisher & Paykel MR700, MR720, MR730, MR480

Fisher & Paykel MR700, MR720, MR730, MR480 technical manual EP1, EP2, EP3, EP4, A5.1

			45
	Errors EP2 to EP4 can be caused for example by abnormal high differential temperatures on the two thermistors or by
	rapidly changing input temperatures.
	EP1	Hardware fault; Q13 short not effective.
	EP2	Low probe temperature (~0 °C).
	EP3	High probe temperature (~70 °C).
	EP4	Partial short between the active probe cable conductors.
A5	MR700 SERIES HUMIDIFIER SERIAL DATA INTERFACE
A5.1	SERIAL DATA FORMAT
	1 byte		: (semi colon) Marks beginning of data record.
	4 bytes ASCII		Temperature Control setting.
	4 bytes ASCII		Airway temperature.
	4 bytes ASCII		Chamber temperature.
	4 bytes ASCII		Heaterplate temperature.
	4 bytes ASCII		Heater wire duty cycle.
	4 bytes ASCII		Heaterplate duty cycle.
	4 bytes ASCII		Chamber Control setting .
	4 bytes *		Status information. (1ASCII 3binary bytes).
	2 bytes		CR, LF (Marks end of data record).

Between each of the above lines there is approximately a 50 ms pause before the next line is transmitted. The complete data record is repeated every 500 to 600 ms (500 ms on a 60 Hz supply, 600 ms with 50 Hz).

Data format is RS232 levels, no handshaking, 9600 baud, 8 bits, no parity, with one stop bit.

Between the semi colon and the line feed there are eight, 4-byte packets of information as shown above.

In each case the first byte of the packet contains an identification letter from ‘a’ through ‘h’ in ASCII.

The format of the 3 bytes following the ASCII I.D. is as shown below.

I.D. a - SET temperature.

I.D. b - Airway temperature.

I.D. c - Chamber temperature.

Range 5.0 to 80.0 °C, decimal point is assumed between 1st and 2nd digits.

I.D. d - Heaterplate temperature.

Range 14.0 to 99.9 °C decimal point assumed, 100 to 135°C no decimal point.

I.D. e - Heater Wire duty cycle.

I.D. f - Heaterplate duty cycle.

Range 0 to 100 %.

I.D. g - Chamber Control Setting.

Range -5.0 to +2.0 decimal point assumed. Plus or minus sign in leading ASCII byte.

I.D. h - Status information.

A5.2 STATUS INFORMATION

The ASCII I.D. is followed by three binary bytes giving alarms and error information, see list below:

Ref. 185040646 MR730/720/700/480 Technical Manual ¯ Revision F ¯ Issued March 2001