Hearth and Home Technologies CB4842MIR, CB4236MIR owner manual Appliance Setup

Page 30

14 Appliance Setup

A. Remove Glass Assembly

See Section J.

B. Remove the Shipping Materials

Remove shipping materials from inside or underneath the firebox.

C. Clean the Appliance

Clean/vacuum any sawdust that may have accumulated inside the firebox or underneath in the control cavity.

D. Accessories

Install approved accessories per instructions included with accessories. Contact your dealer for a list of ap- proved accessories.

WARNING! Risk of Fire and Electric Shock! Use ONLY Hearth & Home Technologies-approved optional acces- sories with this appliance. Using non-listed accessories could result in a safety hazard and will void the warranty.

E. Install the Refractory

An optional weathered brick refractory is available for this appliance. Follow the installation instructions supplied with the refractory.

F. Place the Lava Rock & Vermiculite

See Figures 14.1. 14.2. and 14.4.

It is not necessary to use the entire bag of either product. Save the remaining amount for future use.

G. Place the Rockwool

WARNING! Risk of Explosion! Follow rockwool placement instructions. DO NOT place rockwool directly over burner ports. Replace rockwool material annually. Improperly placed rockwool interferes with proper burner operation.

Rockwool is shipped with this gas appliance.

Place a small amount of 1/2 in. diameter pieces (dime-size) of rockwool on the burner pan so that rock wool touches but does not cover the holes in the burner pan.

It is not necessary to use the entire bag. Save the remaining amount for future use.

Figure 14.3 Placement of Rock Wool

Figure 14.1 Placement of Lava Rock

Vermiculite and

Rock wool

Vermiculite and

lava rock

placement

lava rock

placement on

(shaded areas)

placement on

sides and front

 

sides and front

of hearth pan.

 

of hearth pan.

Figure 14.4 Placement of Lava Rock, Vermiculite & Rock Wool

Figure 14.2 Placement of Vermiculite

30

Heatilator • Caliber Mesh BV Series • 4040-848 Rev G • 10/08

Image 30
Contents Vent Gas Appliance Installation and OperationModels What to do if you smell gasCongratulations Homeowner Reference InformationTable of Contents Installer GuideUser Guide Appliance Setup TroubleshootingReference Materials Warranty Hearth & Home Technologies Limited Warranty CONDITIONS, Exclusions & Limitation of LiabilityWarranty Listing and Code Approvals Gas Fireplace Safety Operating InstructionsYour Fireplace Fan Kit optional Fixed Glass AssemblyRemote Controls, Wall Controls and Wall Switches Clear SpaceFor Your Safety Read Before Lighting Lighting Instructions IPIFrequently Asked Questions Initial Break-in ProcedureAfter Fireplace is Lit Maintenance and Service Maintenance Tasks-HomeownerMaintenance Tasks-Qualified Service Technician Getting Started Typical Appliance SystemDesign and Installation Considerations Tools and Supplies NeededInspect Appliance and Components Negative Pressure Framing and Clearances Selecting Appliance LocationModel # Constructing the Appliance Chase Clearances Rough Opening Model Width Height DepthMantel and Wall Projections MantelsMantel Legs or Wall Projections Termination Locations Vent Termination Minimum ClearancesGas Termination Vent Information and Diagrams Vent GuidelinesVent System Configuration Wall and Ceiling Penetration Framing Vent Clearances and FramingPipe Clearances to Combustibles Vertical Penetration FramingGas and Electrical Connections Install Outside Air Kit Damper AssemblyAppliance Preparation Secure and Level the ApplianceInstall Attic Insulation Shield Installing Vent PipeAssembly of Vent Sections Secure Vent SectionsGas Pressure Gas InformationFuel Conversion Gas ConnectionWiring Requirements Optional Accessories RequirementsElectrical Information Junction Box Installation Wall Switch Installation for Fan OptionalFinishing Facing MaterialAppliance Setup Removing Glass Assembly Install the Log AssemblyGlass Assembly Replacing Glass AssemblyInstall Hood Install TrimInstall Clean Face Components Install Top Latch CoverInstall Bottom Latch Cover Air Shutter SettingInstall Floor Cover Install Firescreen AssemblyTroubleshooting Intellifire Ignition SystemRange. Replace pilot if any damage is detected Appliance Dimension Diagram Reference MaterialsService Parts List CB4236MIRCB4842MIR IPI Valve Assembly Optional Components Model # Description This page intentionally left blank This page intentionally left blank Contact Information