H. Install the Log Assembly
•Base logs have been permanently mounted on the grate assembly and should not be moved. See Figure 14.5.
Figure 14.5 Base Logs
•Install “Y” log on left hand side of grate using locating pins to position. See Figure 14.6.
Figure 14.6 Placing Left Top Log
•Install right top log as shown in Figure 14.7 using locating pins to position log properly.
Figure 14.7 Placing Right Top Log
I. Glass Assembly
WARNING! Risk of Asphyxiation! Handle fixed glass assembly with care. Inspect the gasket to ensure it is undamaged and inspect the glass for cracks, chips or scratches.
•DO NOT strike, slam or scratch glass.
•DO NOT operate fireplace with glass removed, cracked, broken or scratched.
•Replace as a complete assembly.
Removing Glass Assembly
•Remove mesh firescreen (refer to Figure 14.15).
•Lift and pull the upper latch cover towards you to expose the two (36 in. model) or three (42 in. model) glass latches.
•Lift and pull lower latch cover to expose the two (36 in. model) or three (42 in. model) glass latches.
•Rotate the bottom of the screen assembly away from the appliance and lower out of the top retainers.
•Release the top and bottom access latches and rotate the top of the glass assembly away from the top of the appliance.
•Place the glass assembly on a surface that will not scratch the surface of the glass assembly.
Latches
(both bottom
and top)
Glass
Assembly
Figure 14.8 Fixed Glass Assembly
Replacing Glass Assembly
•Replace the glass assembly on the lower access latches.
•Rotate the upper portion of the glass assembly into place.
•Engage the top access latches.
•Engage the lower access latches.
•Reinstall upper latch cover (see Figure 14.12).
•Reinstall lower latch cover (see Figure 14.14).
•Reinstall mesh firescreen (see Figure 14.15).
Heatilator • Caliber Mesh BV Series • | 31 |