R
5100-I WOOD INSERT
BLOWER REPLACEMENT INSTRUCTIONS
Part
TOOLS NEEDED: #2 PHILLIPS SCREWDRIVER
1) Unplug blower cord from outlet.
2)Pull insert out from the fireplace.
3)Remove the 2 Air Control spring handles.
4)Remove the lower grill by removing 2 screws in the center of the grill.
5)Unplug the snap disc
6)Remove screws from blower frame on side of insert.
7)Blower will then slide out through side of insert.
8)Install new blower in same fashion.
9)
10)
11)Push insert back into the fireplace.
12)Plug blower cord back into outlet.
Remove 2 Spring Handles
Figure 14A
FAN SPEED CONTROL ADJUSTMENT, IF NECESSARY*
*The fan Speed Control for this unit is adjusted at the factory, and normally does not require further adjustment.
NOTE: When the speed control is turned clockwise, it will click on to high speed. Continue to turn the speed control clockwise to decrease the speed. At full clockwise, the blower should blow gently, but should not stop.
1.With the unit plugged in, turn the Speed Control Knob to slow. (Full clockwise.)
2.Use a small screwdriver to adjust the fan speed by turning the adjustment mechanism through the hole on the side of the Speed Control.
3.Adjust the speed so the fan runs slowly but does not stop. Turn clockwise to slow the fan and counterclockwise
to increase the speed. | Small Red Female | Small Red Female |
| LEFT FAN | RIGHT FAN |
WIRING DIAGRAM
Figure 14B
Large Blue Male
POWER IN
Large Red Female
Large Blue Female | Large Blue Female |
Large Blue Male
SNAP DISCSPEED
CONTROL
|
|
| Large Red Female |
| |
Large Blue Male | Large Blue Female |
| |||
|
|
| SNAP DISC | ||
AUX POWER |
| ||||
| |||||
LEFT | Large Red Female | ||||
| |||||
| Large Red Female |
|
| ||
Page 14 | January 30, 2004 |