R
5100-I WOOD INSERT
ZERO CLEARANCE ADJUSTABLE TRIM SUPPORT, 2” to 10”
Part No. ADJSPT-12, size 12” x 50”
Included in Kit: (1) Trim Top, (1) Trim Front, (2) Trim Sides,
Tools Needed: Phillips Head Screwdriver, Sheet Metal Shears, Measuring Tape, Gloves
EXPLODED VIEW OF SCISSORS
1.The 10 screws on each set of scissors will already be loose when shipped. See Figure 16A.
2.Expand scissors to desired height. Tighten screws to hold in place using Phillips Head screwdriver. See
Figure 16B.
3.Measure front and side trims to required height to cover scissors and mark pieces for cutting. Cut excess mate- rial from top of trim’s edge, not bottom. This edge will be sharp; wear gloves to prevent injury to your hands. See
Figure 16B.
4.Using sheet metal shears, cut trim along the marked edge. The cut edge fits under lip of top trim, so it allows for some variance in your straight edge.
5.The
6.Place cut edge of trim under top lip and into position on scissors. Place side pieces on first and then front piece. The front piece overlaps side pieces. NOTE: The trim in the Flush Mount Kit is one piece.
7.Once you are satisfied with the positioning, remove trim and set aside.
8.Remove the paper from
NOTE: 3/8” ( 9.5mm) thick tile or like material can be cut to size and fit under lip of top trim edge for a decorative touch.
See Figure 16C.
SCREWS ARE CIRCLED
Figure 16A
EXPAND SCISSORS TO DESIRED
CUT TOP EDGE OF TRIM,
INSTALL FRONT TRIM LAST. NOT BOTTOM EDGE CORNERS OVERLAP SIDE
TRIM PIECES
Figure 16B
Decorative tile may
be installed
Figure 16C
Figure 16D
Page 16 | January 30, 2004 |