R
5100-I WOOD INSERT
PANEL and TRIM SET INSTALLATION
STANDARD Size: | LARGE Size: |
Kit Includes: (2) Side Panels, left & right; (1) Panel Top & Fastener package; (2) Side Trim, left & right; (1) Trim Top & Fastener package.
Tools Needed: Powered Phillips head screw driver and a long handled Phillips screw driver .
Attaching Panels to the Insert
1.Loosely install the 2 side panels, do not tighten, using the cage nuts already attached to the stove. (Note: The sides are not interchangeable).
2.Put top panel in place pushing straight back and then to the right to lock onto top of side panels. Attach the top panel to the sides using the screw already installed at the top of side panels and the panel brackets included in the fasteners package.
3.Tighten side panels to the stove using a long handle screw driver. See Figure 15B.
Panel brackets
Do not tighten sides until top is locked into place
Figure 15A
Back view of top and side panel assembled
Assembling Trim
1.Place protective covering on surface to be used to assemble the trim pieces. Lay the trim face down.
2.Attach the 2 side trim pieces to the top trim at each corner using the “L” bracket included in fasteners package. Slide assembled trim over panel set. See Figure 15C.
View of "L" Bracket
installed
Figure 15C
Figure 13B
January 30, 2004 | Page 15 |