Hearth and Home Technologies 5100I-NL-B Glass Replacement Door Assembly, Cleaning Plated Surfaces

5100-I ACT WOOD INSERT

R

A portion of the combustion air entering the firebox is deflected down over the inside of the door glass. This air flow “washes” the glass, helping to keep smoke from adhering to its surface. When operated at a low burn rate, less air will be flowing over the glass and the smoky, relatively cool condition of a low fire will cause the glass to become coated. Operating the appliance with the Primary Air Control all the way open for 15-20 minutes should remove the built up coating.

	CAUTION
	Handle glass assembly with care.
Glass	When cleaning glass:
Assembly	• Avoid striking, scratching or
	slamming glass.

•Do NOT clean glass when hot.

•Do NOT use abrasive cleaners.

•Use a hard water deposit glass cleaner on white film.

•Use commercial oven cleaner on heavier deposits.

•Remove all residue of oven cleaner or will permanently stain glass on next firing.

•Refer to maintenance instructions.

5.Cleaning Plated Surfaces

•Frequency: As necessary

•By: Homeowner

•Task: Clean all the fingerprints and oils from plated surfaces BEFORE firing the appliance for the first time. If not cleaned properly before lighting your first fire, the oils can cause permanent markings on the plating. Use warm soapy water and a soft rag, glass cleaner and a paper towel, or vinegar and a paper towel to remove the oils. After the plating is cured, the oils will not affect the finish and little maintenance is required. Wipe clean as needed.

CAUTION

•Do not use polishes with abrasives, it will scratch plated surface.

B.Glass Replacement - Door Assembly

•Frequency: As needed

•By: Homeowner / Qualified service technician

•Task: See the following instructions.

1. Ensure that the fire is out and the appliance is cool to the touch.

2.Protect a table or counter top with padding or towels.

3.Remove the door with the broken glass by lifting the door up and off of the hinges.

4.Lay door face down on a table or counter making sure the handle hangs over the edge so the door lays flat, on a soft surface.

5.Remove the screws from each glass retainer and remove the glass. (If screws are difficult to remove, soak with penetrating oil first).

6.Center the new glass with edges evenly overlapping the opening in the door, (i.e. same space top and bottom, left and right sides).

7.Replace the glass retainers. Be careful not to cross thread the screws.

8.Tighten each retainer just a few turns until each is secured. Check again for centering of glass in door frame. Continue to tighten each retainer alternately, a few turns at a time, until the glass is secure. DO NOT OVERTIGHTEN.

9.Replace the door on the appliance.

Quadra-Fire stoves are equipped with ceramic super heat- resistant glass, which can only be broken by impact or misuse. Do not slam stove door or impact the glass. When closing door, make sure that logs do not protrude against the glass. Inspect glass regularly. If you find a crack or break, immediately put the fire out and return the door to your dealer for replacement of glass before further use.

WARNING

Handle glass with care.

• Inspect the gasket to ensure it is

Glassundamaged.

Assembly

• Do NOT strike, slam or scratch glass.

• Do NOT operate appliance with glass

&door assembly removed.

•Do NOT operate with glass cracked, broken or scratched.

WARNING

Fire or Injury Risk

•Use only glass specified in manual.

•DO NOT REPLACE with any other material.

September 1, 2008 438-0380D Page 29