Hearth and Home Technologies 820-0721 warranty Operating Instructions Cont’d, Building a Fire

Page 20

5700 ACT Wood Stove

R

OPERATING INSTRUCTIONS (Cont’d)

IMPORTANT - PLEASE READ BEFORE USING STOVE

For maximum operating efficiency with the lowest emissions, follow these operating procedures:

1.Regardless of desired heat output, when loading stove, burn your Quadra-Fire with both air controls wide open for 5 to 15 minutes.

2.Regulate burn rate (heat output) by using the Primary Control (center under ashcatcher). The Start-Up Air Control (on the right) is mainly for initial start-up and reloading.

3.Heat output settings: Following 5 to 15 minutes of burning with controls wide open (see #1 above):

4.Burn dry, well-seasoned wood.

 

 

 

WARNING: Do not operate with Start-Up Air

BTU / Hr

Start-Up Air Control

*Primary Control

Control in the open position in excess of 15

Below 10,000

Closed after 5 to 15 minutes

Pull to Stop

minutes! "Risk of extreme temperatures! Pro-

10,000 - 15,000

Closed after 5 to 15 minutes

1/8” - 1/2” open

longed operation of this stove with the Start-

Up Air Control in the open position may cause

15,000 - 30,000

Closed after 5 to 15 minutes

1/2” - 1-1/2” open

the combustible materials around the stove to

Maximum Heat

Closed after 5 to 15 minutes

Fully open

exceed safe temperature limits".

NOTE: These are approximate settings, and will vary with type of wood or chimney draft. Due to altitude and other environmental circumstances, this operation information is a guideline only. Similar burn rates may be obtained using other settings unique to your situation.

BUILDING A FIRE

CAUTION: Before lighting your first fire in the stove: 1) Make certain that the baffle is correctly positioned. It should be resting against the rear support; 2) Follow instructions on page 20 for cleaning plated surfaces, and; 3) Remove all labels from glass front.

CAUTION: Never use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter fluid, or similar liquids to start or “freshen up” a fire in this heater. Keep all such liquids well away from the heater while it is in use.

There are many ways to build a fire. The basic principle is to light easily-ignitable tinder or paper, which ignites the fast burning kindling, which in turn ignites the slow-burning firewood. Here is one method that works well:

1. Place several wads of crushed paper on the firebox floor. Heating the flue with slightly crumpled newspaper before

adding kindling keeps smoke to a minimum.

2.Lay small dry sticks of kindling on top of the paper.

3.Open Start-Up Air Control and Primary Air Control fully.

4.Make sure that no matches or other combustibles are in the immediate area of the stove. Be sure the room is adequately ventilated and the flue unobstructed.

5.Light the paper in the stove. NEVER light or rekindle stove with kerosene, gasoline, or charcoal lighter fluid; the results can be fatal.

6.Once the kindling is burning quickly, add several full-length logs 3” (76mm) or 4” (102mm) in diameter. Be careful not to smother the fire. Stack the pieces of wood carefully: near enough to keep each other hot, but far enough away from each other to allow adequate air flow between them.

7.When ready to reload the stove, add more logs. Large logs burn slowly, holding a fire longer. Small logs burn fast and hot, giving quick heat.

8.Adjust the Start-Up Air Control and Primary Control; the more you close down the Primary Control, the lower and slower the fire will burn. The more you open the Primary Control, the more heat will be produced. The Start-Up Air Control is only used for the first 5 to 15 minutes.

As long as there are hot coals, repeating steps 7 and 8 will maintain a continuous fire throughout the season.

NOTE: The special high temperature paint that your stove is finished with will cure as your stove heats. You will notice an odor and perhaps see some vapor rise from the stove surface; this is normal. We recommend that you open a window until the odor dissipates and paint is cured.

NOTE: Stove should be run full open for 15 minutes a day to keep air passages clean.

WARNING! ALWAYS OPERATE THIS APPLIANCE WITH THE DOOR CLOSED AND LATCHED EXCEPT DURING START-UP AND RE- FUELING .

WARNING! DO NOT LEAVE THE FIRE UNATTENDED WHEN THE DOOR IS UNLATCHED. UNSTABLE FIREWOOD COULD FALL OUT OF THE FIREBOX CREATING A FIRE HAZARD TO YOUR HOME.

Page 20

250-7090E

September 1, 2008

Image 20
Contents Wood Stove Sample of Serial Number / Safety Label Location On right side of insert as face the applianceTable of Contents Listings & Safety Cautions Installation Materials Needed for SafetyDimensions Locating Your StoveSerial Number / Safety Label Location On Back of Stove Clearances to Combustibles UL and ULCFloor Protection USAFloor Protection Cont’d Alternate Materials WorksheetChimney HEIGHT/DRAFT Masonry Chimney Flue SystemsMasonry Chimney Cont’d Solid Pack Chimney with Metal Supports AS a Thimble Solid Pack Chimney with Metal Supports AS a Thimble Cont’d Connection to a Metal PRE-FABRICATED Chimney Interior ChimneyMobile Home Installation ASH Removal System ARS Installation ARS Operating and CleaningLEG Model Pedestal ModelPedestal or LEG KIT Installation Pedestal Model LEG ModelInstallation of Optional BLOWER, Part Adjusting the Blower Speed CONTROL, if NecessaryOutside AIR KIT Installation Pedestal ModelAIR Controls Operating Instructions Cont’d Building a FireOpacity Burn RatesWood Selection and Storage Blower Operating InstructionsMaintenance and Glass Care Chimney CleaningCreosote Glass CareGlass Replacement Replace with 5mm ceramic glass onlySpring Handle Warning Door Handle AssemblyBaffle Removal and Installation Appliance AccessoriesService Parts DOOR, Glass and Door Handle Assembly Exploded ViewsService And Maintenance Log Service And Maintenance Log Cont’d Homeowner’s Notes Warranty Policy CONDITIONS, Exclusions & Limitation of LiabilityHearth & Home Technologies Limited Warranty Cont’d ACT Wood Stove

820-0721 specifications

Hearth and Home Technologies (HHT) 820-0721 is a premium fireplace and heating solution that exemplifies modern design and innovative technology. Designed for comfort and efficiency, the 820-0721 model brings together aesthetic appeal and advanced functionality, making it an ideal choice for homeowners seeking to enhance their living spaces.

One of the key features of the HHT 820-0721 is its advanced heating capabilities. Utilizing cutting-edge technology, this fireplace delivers impressive heating performance while maintaining energy efficiency. The model is engineered to provide consistent warmth, ensuring that any room remains cozy even during the coldest months of the year. With its ability to efficiently convert fuel into heat, users can enjoy optimal warmth while minimizing energy costs.

Additionally, the HHT 820-0721 incorporates a range of customization options. Homeowners can choose from a variety of styles, finishes, and sizes, allowing them to tailor the fireplace to their specific decor preferences. The sleek and modern design complements a wide array of interiors, from traditional to contemporary, making it a versatile addition to any home.

The technology behind the HHT 820-0721 is also noteworthy. Equipped with advanced safety features, this fireplace includes an automated shut-off system that ensures safe operation. The unit is designed to prevent overheating and includes protective screens that mitigate the risk of accidental burns. These safety enhancements provide peace of mind for families who prioritize both style and security.

The HHT 820-0721 is also user-friendly, featuring intuitive controls that make it easy to adjust temperature settings. Moreover, many models come with remote control options, allowing users to operate their fireplace from anywhere in the room. This convenience adds to the overall appeal of the unit, making it simple to create the perfect ambiance without the hassle of manual adjustments.

In summary, the Hearth and Home Technologies 820-0721 is a premium fireplace solution that excels in heating efficiency, design flexibility, and safety features. Its modern aesthetics, combined with advanced technology and ease of use, make it an outstanding choice for those looking to enhance their home's comfort and visual appeal. As homeowners continue to seek innovative heating solutions, the HHT 820-0721 stands out as a leader in the market.