Hearth and Home Technologies 820-0721 Door Handle Assembly, Baffle Removal and Installation

Page 24

5700 ACT Wood Stove

R

DOOR HANDLE ASSEMBLY

NOTE: SEE PAGE 18 FOR OPERATING INSTRUCTIONS

1.

Install washer on door handle shaft.

2.

Slide door handle through door.

3.

Install second washer(s) as shown.

4.

Install key in groove.

5.

Align groove in latch cam with key; slide latch cam over

 

shaft.

6.

Install secondary latch included in the Component Pack

 

inside the firebox.

7.

Install locknut.

Latch Cam

Locknut

Secondary

Latch

Door Cross Section (example)

3" (76mm) clearance

required from bend in Door Handle Rod to end of Spring Handle.

Spring

Handle

Door Handle

Spacing

Washers

Square Key

Caution! Do not overtighten locknut. Door

handle needs to move SMOOTHLY.

8. Install spring handle turning in a counter-clockwise motion

on handle leaving a 3” (76mm) clearance from bend in

door handle rod to end of spring handle. See Figure

24.

FIGURE 24A

SPRING HANDLE WARNING!

3” (76mm) clearance is required from bend in Door Handle Rod to end of the Spring Handle. If installed within that 3” (76mm) area, Spring Handle will get hot and may cause injury.

BAFFLE REMOVAL AND INSTALLATION

1.Remove all ash from the firebox, and extinguish all hot embers before disposal into a metal container.

2.With a 3/16” allen wrench, remove the 2 front secondary combustion tube retainer bolts on the secondary air channel under the end of the front tubes. See Figure 24B. NOTE: Soak the bolts with penetrating oil for at least 15 minutes before trying to remove them.

3.To remove the secondary combustion tubes, slide the tube to one side until one end is out of its hole. Then, while lifting that end of the baffle, pull the tube up over the secondary air channel and out of the hole at the other end.

NOTE: When replacing the secondary tubes, be sure the tube with the larger holes is placed in the front or your stove will not operate properly.

4.Slide baffle and ceramic blanket forward to front of stove, tilt down and slide to the door. Tilt to one side and slide both through door at the same time. Keep them tilted as you lift it out of the door. See Figure 24C.

5.To install the baffle and ceramic blanket, repeat steps 2 through 4 in reverse. Be sure that the fiber board baffle is pushed back fully and the blanket is down flat. The front of the blanket should be flush with the front of the baffle.

First tube has larger holes

Allen wrench on retainer bolt

FIGURE 24B - Allen wrench on retainer bolt.

FIGURE 24C - Baffle with ceramic blanket on top.

Page 24

250-7090E

September 1, 2008

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Wood Stove Sample of Serial Number / Safety Label Location On right side of insert as face the applianceTable of Contents Listings & Safety Cautions Installation Materials Needed for SafetyDimensions Locating Your StoveSerial Number / Safety Label Location On Back of Stove Clearances to Combustibles UL and ULCFloor Protection USAFloor Protection Cont’d Alternate Materials WorksheetChimney HEIGHT/DRAFT Flue Systems Masonry Chimney Cont’dMasonry Chimney Solid Pack Chimney with Metal Supports AS a Thimble Solid Pack Chimney with Metal Supports AS a Thimble Cont’d Connection to a Metal PRE-FABRICATED Chimney Interior ChimneyMobile Home Installation ASH Removal System ARS Installation ARS Operating and CleaningLEG Model Pedestal ModelPedestal or LEG KIT Installation Pedestal Model LEG ModelInstallation of Optional BLOWER, Part Adjusting the Blower Speed CONTROL, if NecessaryOutside AIR KIT Installation Pedestal ModelAIR Controls Operating Instructions Cont’d Building a FireOpacity Burn RatesWood Selection and Storage Blower Operating InstructionsMaintenance and Glass Care Chimney CleaningCreosote Glass CareGlass Replacement Replace with 5mm ceramic glass onlyDoor Handle Assembly Baffle Removal and InstallationSpring Handle Warning Accessories Service PartsAppliance DOOR, Glass and Door Handle Assembly Exploded ViewsService And Maintenance Log Service And Maintenance Log Cont’d Homeowner’s Notes Warranty Policy CONDITIONS, Exclusions & Limitation of LiabilityHearth & Home Technologies Limited Warranty Cont’d ACT Wood Stove

820-0721 specifications

Hearth and Home Technologies (HHT) 820-0721 is a premium fireplace and heating solution that exemplifies modern design and innovative technology. Designed for comfort and efficiency, the 820-0721 model brings together aesthetic appeal and advanced functionality, making it an ideal choice for homeowners seeking to enhance their living spaces.

One of the key features of the HHT 820-0721 is its advanced heating capabilities. Utilizing cutting-edge technology, this fireplace delivers impressive heating performance while maintaining energy efficiency. The model is engineered to provide consistent warmth, ensuring that any room remains cozy even during the coldest months of the year. With its ability to efficiently convert fuel into heat, users can enjoy optimal warmth while minimizing energy costs.

Additionally, the HHT 820-0721 incorporates a range of customization options. Homeowners can choose from a variety of styles, finishes, and sizes, allowing them to tailor the fireplace to their specific decor preferences. The sleek and modern design complements a wide array of interiors, from traditional to contemporary, making it a versatile addition to any home.

The technology behind the HHT 820-0721 is also noteworthy. Equipped with advanced safety features, this fireplace includes an automated shut-off system that ensures safe operation. The unit is designed to prevent overheating and includes protective screens that mitigate the risk of accidental burns. These safety enhancements provide peace of mind for families who prioritize both style and security.

The HHT 820-0721 is also user-friendly, featuring intuitive controls that make it easy to adjust temperature settings. Moreover, many models come with remote control options, allowing users to operate their fireplace from anywhere in the room. This convenience adds to the overall appeal of the unit, making it simple to create the perfect ambiance without the hassle of manual adjustments.

In summary, the Hearth and Home Technologies 820-0721 is a premium fireplace solution that excels in heating efficiency, design flexibility, and safety features. Its modern aesthetics, combined with advanced technology and ease of use, make it an outstanding choice for those looking to enhance their home's comfort and visual appeal. As homeowners continue to seek innovative heating solutions, the HHT 820-0721 stands out as a leader in the market.
Top Page Image Contents