R
Isle Royale Wood Stove
Masonry Chimney Liner (Cont'd)
C. Installing Chimney Components
Chimney Connector
Wood Stud 2 in. (51mm) 
Clearance from 
chimney wall
Header
Fireclay liner 5/8 in. (16mm) Minimum or Equivalent.
Sill support
Fireclay liner 5/8 in. (16mm) Minimum or Equivalent.
Single wall connector or stove pipe.
This must be at least 24 gauge mild steel or 26 gauge blue steel. The sections must be attached to the appliance and to each other with the crimped (male) end pointing toward the stove. All joints, including the connection at the fl ue collar, should be secured with 3 sheet metal screws. Make sure to follow the minimum clearances to combustibles. Where passage through the wall, or partition of combustible construction is desired in Canada, the installation shall conform to
A listed connector (vented) must be used when installing this unit in a mobile home. The listed connectors must conform to each other to ensure a proper fi t and seal.
Crimped | Flue Gas | |
End | ||
Direction | ||
Toward | ||
| ||
Stove |
|
Thimble Assembly: 12 in. (305mm) of brick separation between clay liner and combustibles.
Figure 17.1
WARNING
Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to the owner’s information manual provided with this appli- ance. For assistance or additional information consult a qualifi ed installer, service agency or your dealer.
Secure pipe sections with a
minimum of 3 screws
Figure 17.2 Chimney Connector (Stove Pipe)
WARNING
Fire Risk.
Follow Chimney Connector Manufacturer’s
Instructions for Proper Installation.
ONLY use connector:
•Within the room, between appliance and ceiling or wall. Connector shall NOT pass through:
•Attic or roof space
•Closet or similar concealed space
•Floor or ceiling
Maintain minimum clearances to combustibles
November 22, 2011 | Page 17 | |
|
|