Hearth and Home Technologies 823-0170 - MBK Operating The Top Loading Option, Burn Rates

Page 24

R

Isle Royale Wood Stove

F. Operating The Top Loading Option

NOTICE: SHIPPING BOLTS MUST BE REMOVED PRIOR TO REMOVING GRIDDLE.

NOTE: There are 3 fi ber door handles for this appliance. They are for the door, baffl e by-pass handle and the top-loading griddle slot.

1.Using a 7/16 wrench, remove the 2 shipping bolts under- neath the griddle before lifting the griddle off of stove.

2.Open by-pass door by moving the side handle towards rear of stove.

3.Wait 15 seconds to allow smoke to clear out of fi rebox.

4.Slowly open top loading door and load unit with fuel.

5.Close the top door.

6.Close the by-pass door (move side handle towards front of stove.)

WARNING

Injury Risk.

Remove the door handle during operation to prevent:

•Handle may overheat and may cause burns to your hands.

Wear protective gloves when operating the draft control knobs as they become hot during operation

WARNING

Fire Risk.

•ALWAYS OPERATE THIS APPLIANCE WITH THE DOOR CLOSED AND LATCHED EXCEPT DURING START-UP AND RE-FUELING OR WHEN USING THE FIRESCREEN.

•OPERATING WITH THE DOOR PARTLY OPEN CAN CAUSE:

•HOT EMBERS OR SPARKS TO FALL OUT

•FLAMES AND SMOKE MAY BE DRAWN OUT FROM FIREBOX OPENING

G. Heat Output Settings

For maximum operating effi ciency with the lowest emissions, follow these operating procedures:

1.Regardless of desired heat output, when loading stove, burn it with both air controls wide open for 5 to 15 min- utes.

2.Regulate burn rate (heat output) by using the Primary Air Slide Control (center under ashcatcher). The Start-Up Air Control (on the right) is used for initial start-up and reloading.

3.Heat output settings are listed below, following 5 to 15 minutes of burning with controls wide open (see #1 above):

4.Burn dry, well-seasoned wood.

H.Burn Rates

1.High Burn Rate - Maximum Heat* - 40,000+ BTU/hr

•Close Start-Up Air Control after 5 to 15 minutes, fully open (all the way to the left) the Primary Air Slide Control.

2. Medium-High Burn Rate* - 15,000 to 40,000 BTU/hr

•Close Start-Up Air Control after 5 to 15 minutes, open the Primary Air Slide Contro 1-1/2 inch to 1-1/8 inch.

3. Medium-Low Burn Rate* - 10,000 to 15,000 BTU/hr

•Close Start-Up Air Control after 5 to 15 minutes, open the Primary Air Slide Contro 1-1/8 inch to 1/2 inch.

4. Low Burn Rate* - Below 10,000 BTU/hr

•Close Start-Up Air Control after 5 to 15 minutes, slide the Primary Air Slide Control all the way to the right.

*NOTE: These are approximate settings, and will vary with type of wood or chimney draft. Due to altitude and other environmental circumstances, this operational information is a guideline only.

WARNING

Risk of extreme temperatures!

•Do not operate with Start-Up Air Control in the open position in excess of 15 minutes!

•Prolonged operation with the Start-Up Air Control in the open position may cause the combustible materials around the stove to exceed safe temperature limits.

Page 24

250-5763E

November 22, 2011

 

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Non-Catalytic, Top-load, Wood Heater MBK PMHHot glass will cause burns Isle Royale Wood Stove Welcome to the Quadra-Fire FamilyTable of Contents Isle Royale Wood Stove Listing and Code Approvals Appliance Certifi cationBTU & Effi ciency Specifi cations Mobile Home ApprovedFire Safety Isle Royale Wood Stove Getting StartedNegative Pressure WindwardFlue Draft Considerations Venting SystemsTools And Supplies Needed Inspect Appliance & Components and Pre-Burn Check ListTypical Stove Systems Masonry ChimneyIsle Royale Wood Stove Dimensions and Clearances Appliance DimensionsFor TOP Vent Installations Clearances To Combustibles UL And ULCIsle Royale Wood Stove Installation Considerations Hearth Protection RequirementsSee Figure USA Required Canada RecommendedConverting Collar For Rear Vent Installation Reversible Flue CollarRear Flue Defl ector Cover Plate Outside Air Kit Installation Installation Of Optional BlowerItems Needed for Installation 4 inch 102mm diameter Isle Royale Wood Stove Chimney Requirements Venting ComponentsChimney Systems Components Air ClearancesInstructions Masonry Chimney Liner Chimney Height / Rise and RunInstalling Chimney Components Masonry Chimney Liner ContdChimney Termination Requirements RuleIsle Royale Wood Stove Mobile Home Installation 629M, Standard for Factory Built ChimneysAdjusting The Blower Speed Control Door Handle Assembly Isle Royale Wood Stove Appliance Set-UpSymptoms of Over-Firing Isle Royale Wood Stove Operating InstructionsOver-Firing Your Appliance Wood Selection and Storage Fire RiskBurning Process Kindling or First StageSecond Stage Combustible/Non-Combustible Materials Air ControlsHeat Output Settings Operating The Top Loading OptionBurn Rates Building a Fire Frequently Asked Questions Optional Blower Operating InstructionsOpacity Smoke Clear SpaceGeneral Maintenance Cleaning Plated Surfaces Glass Cleaning Frequency As desiredDisposal of Ashes Inspect Firebrick & Replacement Instructions Glass ReplacementAppliance Inspection Routine Quick Reference Maintenance Guide MonthlyIsle Royale Wood Stove Troubleshooting Guide Start Fire Problems Possible Cause SolutionService Parts Exploded Drawing Part number list on followingNon-Catalytic, Top-Load Wood StoveService Parts and Accessories #9 Baffl e AssemblyStocked At DepotStocked at Depot #13 Door Assembly 13.9 13.1 13.8 13.2 13.7 13.4 13.3 13.5 13.6Stocked at Depot #19 Brick Assembly Brick, Uncut Must specify size when ordering19.5 19.3 Accessories Service And Maintenance Log Date of Service Performed By Description of ServiceWarranty Policy Isle Royale Wood Stove Contact Information
Top Page Image Contents