R
Isle Royale Wood Stove
7 Appliance Set-Up
B. Adjusting The Blower Speed Control
A. Door Handle Assembly
| If Necessary | |
Included in Kit: 1 locknut, 1 porcelain handle, 1 screw | NOTE: When the speed control is turned clockwise, it will | |
adapter, 1 gold or nickle handle, 1 square key, 4 spacing | ||
click on to high speed. Turn the speed control | ||
washers, 1 cam latch | ||
clockwise to decrease the speed. At full | ||
Tools Needed: 9/16 box end wrench, fl at head screwdriver. | ||
clockwise, the blower should blow gently, but | ||
| ||
| should not stop. |
Latch Cam |
| |
| Door Cross Section | |
Locknut |
|
|
|
| Handle |
Spacing Washers | Teflon Washer |
|
| DO NOT |
|
| REMOVE | Square Key |
|
| |
1.With the stove plugged in, turn the speed control knob to slow (full clockwise).
2.With a small screwdriver, adjust the blower speed by turning the adjustment mechanism through the hole on the side of the speed control.
3.Adjust the speed so the blower runs slowly, but does not stop. Turn clockwise to slow the blower and counterclockwise to increase the speed.
Figure 20.1
Thread
End
Porcelain
Handle
Figure 20.2
1.Install tefl on washer on door handle shaft.
2.Slide door handle through door.
3.Install spacing washers(s) as showin in Figure 20.1.
4.Install key in groove.
5.Align groove in latch cam with key; slide latch cam over shaft.
6.Install locknut but do not overtighten, the handle needs to move smoothly.
INSTALL PORCELAIN HANDLE:
1.Insert handle adapter with threads going into the porce- lain handle. Figure 20.2.
2.Thread in completely, using a fl at head screwdriver.
Page 20 | November 22, 2011 | |
|