Hearth and Home Technologies 823-0170 - MBK owner manual Chimney Termination Requirements, Rule

Page 18

R

Isle Royale Wood Stove

D. Chimney Termination Requirements

Follow manufacturer’s instructions for clearance, securing

ashing and terminating the chimney.

Must have an approved and listed cap

Must not be located where it will become plugged by snow or other material

Must terminate at least 3 feet (91cm) above the roof and at least 2 feet (61cm) above any portion of the roof within 10 feet (305cm).

Must be located away from trees or other structures

NOTE:

Chimney performance may vary.

Trees, buildings, roof lines and wind conditions affect performance.

Chimney height may need adjustment if smoking or overdraft occurs.

E. 2-10-3 Rule

These are safety requirements and are not meant to assure proper fl ue draft.

Less than 10 ft. (305cm)

3 ft. (91cm)

Minimum

2 ft. (61cm)

10 ft. (305cm) To Nearest Roofline

2 ft. (61cm)

3 ft. (91cm)

Minimum

Pitched Roof

Figure 18.1

10 ft. (305cm) or more

Wall or Parapet

3 ft. (91cm) Minimum

3 ft. (91cm) Minimum

Less than 10 ft. (305cm)

2 ft. (61cm)Minimum

 

Figure 18.2

Flat Roof

 

 

 

 

 

 

 

 

 

Page 18

250-5763E

November 22, 2011

 

 

Image 18
Contents Non-Catalytic, Top-load, Wood Heater MBK PMHHot glass will cause burns Isle Royale Wood Stove Welcome to the Quadra-Fire FamilyTable of Contents BTU & Effi ciency Specifi cations Isle Royale Wood Stove Listing and Code ApprovalsAppliance Certifi cation Mobile Home ApprovedFire Safety Isle Royale Wood Stove Getting StartedNegative Pressure WindwardTools And Supplies Needed Flue Draft ConsiderationsVenting Systems Inspect Appliance & Components and Pre-Burn Check ListTypical Stove Systems Masonry ChimneyIsle Royale Wood Stove Dimensions and Clearances Appliance DimensionsFor TOP Vent Installations Clearances To Combustibles UL And ULCSee Figure Isle Royale Wood Stove Installation ConsiderationsHearth Protection Requirements USA Required Canada RecommendedConverting Collar For Rear Vent Installation Reversible Flue CollarRear Flue Defl ector Cover Plate Outside Air Kit Installation Installation Of Optional BlowerItems Needed for Installation 4 inch 102mm diameter Isle Royale Wood Stove Chimney Requirements Venting ComponentsChimney Systems Components Air ClearancesInstructions Masonry Chimney Liner Chimney Height / Rise and RunInstalling Chimney Components Masonry Chimney Liner ContdChimney Termination Requirements RuleIsle Royale Wood Stove Mobile Home Installation 629M, Standard for Factory Built ChimneysAdjusting The Blower Speed Control Door Handle Assembly Isle Royale Wood Stove Appliance Set-UpOver-Firing Your Appliance Wood Selection and Storage Symptoms of Over-FiringIsle Royale Wood Stove Operating Instructions Fire RiskBurning Process Kindling or First StageSecond Stage Combustible/Non-Combustible Materials Air ControlsHeat Output Settings Operating The Top Loading OptionBurn Rates Building a Fire Opacity Smoke Frequently Asked QuestionsOptional Blower Operating Instructions Clear SpaceGeneral Maintenance Cleaning Plated Surfaces Glass Cleaning Frequency As desiredDisposal of Ashes Inspect Firebrick & Replacement Instructions Glass ReplacementAppliance Inspection Routine Quick Reference Maintenance Guide MonthlyIsle Royale Wood Stove Troubleshooting Guide Start Fire Problems Possible Cause SolutionNon-Catalytic, Top-Load Service PartsExploded Drawing Part number list on following Wood StoveStocked Service Parts and Accessories#9 Baffl e Assembly At DepotStocked at Depot #13 Door Assembly 13.9 13.1 13.8 13.2 13.7 13.4 13.3 13.5 13.6Stocked at Depot #19 Brick Assembly Brick, Uncut Must specify size when ordering19.5 19.3 Accessories Service And Maintenance Log Date of Service Performed By Description of ServiceWarranty Policy Isle Royale Wood Stove Contact Information