Omron DDAA1000/SRM manual Antenna Connectoin Type, Power Connector, Teminal Block

Page 6

DDAA1000/SRM User Guide

Table 1: LED Description

	CD	Carrier Detect LED. When the units have established an RF Link this LED will be on solid.

	Tx	Transmit LED. Will flash when the unit is sendng data to the receiving unit.

	Rx	Receive LED. Flashes when receiving data being sent by transmitting unit.

	Pwr	Power LED. Flashes on solid when unit has power applied.

	Status	The status LED will be off when communication is working properly. LED flashes or stays on
	Status	steadily when a communication problem exists. (Master unit only)


Figure 2: Normal User Connection

Power

Antenna

Antenna Connectoin Type

Thread Type	Standard Thread

Gender	Female

Connector	SMA

Power Connector

Dimensions of Post	2 mm

Dimensions of Hole	6.5 mm

Polarity	Center Pin Positive

Voltage	12VDC Nominal , 10.5-18VDC

Current	160mA Idle, 660mA Peak on Transmit

Teminal Block

Wire Size	12-26 AWG

4	DATA-LINC GROUP

PN 161-09981-002C

rev 8/04

Image 6

Contents DDAA1000/SRM FCC Notification Product User GuideTable of Contents DATA-LINC Group Introduction DDAA1000 and DD1000Power Connector Antenna Connectoin TypeTeminal Block Discrete Operation ConnectionsPoint-to-Point Discrete Operation Master RemotePoint-to-Multipoint Discrete Operation MasterPoint-to-Point Analog System Supply loop powerAnalog Operation Needed. The DDAA1000 unites do notConnection of a flow meter to the DDAA1000/SRM unit Master or RemoteFactory Configuration Process Point-to-Multipoint Analog SystemPoint-to-Multipoint Analog Operation Point-to-Multipoint Analog Example RemoteChanging System or Radio Configurations Layout DrawingTechnical Specifications Troubleshooting Technical Support Product WarrantyReturn Material Authorization Contact InformationAppendix a TOPDDAA1000 DD1000 Configuration Appendix BDATA-LINC Group Ddaa Eeprom MENU** *SET Caplck DATA-LINC Group Appendix C Radio Configuration Terminal SettingsMain Menu Point-to-Point Remote Main Menu Option 0 Set Operation ModePoint-to-point Master Point-to-Multi-Point MasterPoint-to-Point Repeater Point-to-Point Remote/Master SwitchableDDAA1000/SRM User Guide Point-to-Point Remote/Repeater Point-to-Multi-Point RepeaterMain Menu Option 1 Set Baud Rate Available data word length and parity selectionsModBus RTU Main Menu Option 2 Edit Call Book Call Book MenuEdit Call Book in Multi-Point Systems Entry Number Repeater 000-0000Main Menu Option 3 Edit Radio Transmission Characteristics FreqKeyMax Packet Size and 2 Min Packet Size Selections DDAA1000/SRM User Guide Minimum Packet Size Settings bytes Maximum Packet Size Settings where RF Data Rate=3Xmit Rate RF Data RateRemote Security DDAA1000/SRM User Guide RF Xmit PowerPower Transmit Settings RTS to CTSDDAA1000/SRM User Guide Lowpower Mode High NoiseMCU speed Average Noise Level Average Signal LevelMain Menu Option 4 Show Radio Statistics Overall Rcv Rate %Radio Temperature DDAA1000/SRM User Guide Number of DisconnectsMulti-Point Operation Main Menu Option 5 Edit Multi-Point Parameters Multi-Point ParametersSubNet ID DiagnosticsRemote/Repeater Radio IDMain Menu Option 8 Password Changing a Password Disabling PasswordDDAA1000/SRM and DD1000/SRM Placement Locations