3SETTING AND FASTENING THE DOOR:
A.Place three 3/8" beads of sealant.3ODFHWKHŵUVWEHDGVVHDODQWLQIURQWRIWKHEDVH of the interior sill pan lip. This bead should also continue up the corner of the sill pan
DWHDFKHQGVHDOLQJWKHYHUWLFDOMRLQWVRIWKHVLOOSDQOHJV&RQWLQXHWKHŵUVWEHDGXS RQWRHDFKMDPEVLGHRIWKHURXJKRSHQLQJ7KHVHFRQGEHDGVKRXOGEHDSSUR[LPDWHO\ IURPWKHH[WHULRUHGJHRIWKHURXJKRSHQLQJUXQQLQJIURPMDPEWRMDPEZLWKD break in the middle of the opening. Place a third sealant bead in the groove of the sill
VXSSRUWIURPHQGWRHQGRU~IURPWKHH[WHULRUHGJHRIWKHZRRGEORFNLQJ
1/2" | 1st | Bead |
| 3A |
|
| 2nd Bead |
| |
6" |
|
|
| |
|
| Leave | ||
|
|
| ||
|
|
| in | a 2" break |
|
| INTERIOR | center of pan | |
|
|
| ||
|
| SILL |
| |
|
|
| PAN |
|
|
|
| LIP |
|
3rd Bead |
|
|
|
|
6” | 3A |
1 |
|
2 |
|
3 |
|
Applications without sill pan
TWO OR MORE PEOPLE WILL BE REQUIRED FOR THE FOLLOWING STEPS:
Designer Series Doors:
B. Cut and remove the strap that runs from the door lock to the sill of the door.
For doors with no lock/bore:
C.Remove the screws and blocking from the head and sill. Caution: The door panels will swing freely.
D. Insert the door from the exterior of the building. | 3D | |
DO NOT slide the bottom of the door into the | ||
| ||
opening. Sliding will damage the sealant lines. |
| |
Place the bottom of the door at the bottom |
| |
of the opening, then tilt the top into position. |
| |
Center the door between the sides of the |
| |
opening to allow clearance for shimming, and |
| |
insert one roofing nail in the first hole from |
| |
the corner on each end of the top nailing fin. |
| |
These are used to hold the door in place while |
| |
shimming it plumb and square. |
|
E.Plumb and square door. Place shims at each
hinge and lock strike location between the | 3E |
door and the sides of the opening. Keep shims EDFNIURPWKHLQWHULRUIDFHRIWKHGRRU frame. Insert shims in other locations as needed VWDUWLQJXSIURPWKHERWWRPRIWKHGRRUWR square it in the opening. Check for frame twist; confirm consistent weatherstrip compression DURXQGWKHSHULPHWHURIWKHGRRU0DNHVXUH the panels are even across the bottom.
Note: On center latch double doors the lock strike will not be shimmed since it is located in the center of the unit. DO NOT over shim.