England's Stove Works 49-SHC22, 10-CDV Accessory Items, Thermostat, AC-117, AC-117BN Lip Trim

Page 22

ACCESSORY ITEMS

The following accessories can be added to your unit at anytime after purchase; however, let the unit cool down before adding any accessories.

Thermostat

WALL: An external wall thermostat (such as our Part # GU-1E30-914) can be used on our corn/pellet units as long as it is a low-voltage that works with millivolt systems. After unplugging the unit, locate the jumper wire (J-3) on the bottom of the control panel. The two screws should then be loosened and the jumper wire removed from the board. Next, the two thermostat lead wires should be slipped into these openings and the screws tightened; the jumper wire should be saved for future operation without a thermostat.

The unit will operate differently once the wall thermostat is connected – we recommend the Control Board be set at “9” on Heat Range and Blower Speed while using the thermostat. Refer to the section on “Start-up Procedure” for information on cold starts.

AC-117, AC-117BN Lip Trim

There are two pieces of J-Channel trim in this kit that snap onto the ash apron and top lips of the stove. Match the channel with the correct edge of the lip, then remove the protective covering from the trim and force the piece onto the edge. Although it should stay in place, stove cement can be used to secure it if necessary.

AC-118, AC-118BN Window Trim

Window trim can be attached by using the provided spring clip(s) and some high temperature silicone (optional). Insert the tee end of the spring clip into the channel on the edge of the trim – then, turn the clip and set the other end of the clip into the channel. The spring clip will hold well if it is placed on the top edge of the trim before placing the trim in the window of the stove. Place the top edge with the clip into the window opening, then push the bottom edge of the trim flush with the window. We also suggest that high temperature silicone be used on the corners, to ensure the trim will stay in place.

Accessories can be ordered from the factory at:

(Parts orders ONLY) -- (800) 516-3636, or on our web site: www.englanderstoves.com .

Questions/Problems: Please call Customer Service at (800) 245-6489.

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Model Numbers 10-CDV 49-TRC22 49-SHC22 Must be maintainedWishing you years of efficient, quality and comfy heating Important Information Important Notice Unit Preparation Important Information Read Before OperatingPage Page Do not Connect to ANY AIR Distribution Duct or System Burning Solid Fuels Setting the StirrerWood Pellets Flue System Be sure to check local codes in your areaThrough the Ceiling Mobile Home InstallationOutside Air Outside Combustion Air Intake Floor Protection Floor and Wall ProtectionWall Protection START- UP Procedures Operating InstructionsPellet START-UP Procedure Corn START-UP ProcedureTo remove the stirrer for burning pellets SHUT-DOWN Procedure CodesDaily Operation ASH Removal and Disposal Annual CleaningAsh Pan Semi-Weekly Ash Removal Maintenance Finish Auger Removal and ReplacementGlass Control Board Recommended Heat RangesCircuit Board Functions Component Operation Start Operation ENDAC-117, AC-117BN Lip Trim Accessory ItemsThermostat AC-118, AC-118BN Window TrimOptions Replacement PARTS, Accessories and OptionsCustomer Service Department Box Parts Orders only Monroe, VA Questions FaxCorn Stove Exploded View Diagram Illustration Adjusting your Hopper Lid Latch Dimensions of your corn/pellet unit Directions for Installation Legs or PedestalTROUBLE-SHOOTING Guide Problem Cause SolutionProblem Warranty is not Transferable Page Dealer Information Unit Information
Top Page Image Contents