England's Stove Works 49-TRC22, 10-CDV Corn START-UP Procedure, Pellet START-UP Procedure

Page 14

CORN START-UP PROCEDURE

When starting the stove with corn, push the “AIR ON TEMP” button and hold, which will rotate the stirrer mechanism in the burn pot. Release the button when the stirrer is strait up (in the “12:00” position) before following the above instructions concerning placing the handful of pellets in the fire pot and starting your fire.

Changing from Corn to Pellets

Your unit was primarily designed to burn corn, but will also burn hardwood pellets. Your unit comes ready to burn corn by default; if you wood like to burn pellets in your unit, follow the steps below.

WARNING: Do not open the door on this unit if the stirrer is still moving! See instructions on “Setting the Stirrer” earlier in this manual.

NOTE: Before doing these steps make sure the unit is out and completely cold!!

1.Remove the stirrer shaft (See Illustration 2)

2.Unplug the unit and plug back in, then press the Heat Range down and Blower Speed down buttons at the same time and release. You should see a “P” in the Heat Range window.

3.Follow lighting instructions.

PELLET START-UP PROCEDURE

NOTE: When burning only pellets, remove stirrer from fire pot. See Illustration 2. While you will not follow the instructions in the above “Corn Start-Up Procedure,” you will follow the instructions on “Changing from Corn to Pellets” and the other “Start-Up Procedures” in the preceding “Operating Instructions” section of this manual.

If the unit does not start or maintain a fire, you will receive an E-2in the Heat Range and Blower Speed window of the Control Board. If this occurs, wait until unit has cooled completely down and repeat.

Set Screw

Locking

Collar

Illustration 2

To remove the stirrer for burning pellets

While the unit is COLD and the unit is off, press and hold the Air On Temp button until the stirrer is at the “12:00” position; loosen the Allen head Set Screw (marked in Illustration 2). Slide the locking collar (also marked in Illustration 2) to the fire pot. Lifting the fire pot and stirrer at the same time, remove the stirrer from the fire pot and replace fire pot back into the unit.

NOTE: When replacing the fire pot, notice there is a welded piece that is always set toward the back of the fire box.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Model Numbers 10-CDV 49-TRC22 49-SHC22 Must be maintainedWishing you years of efficient, quality and comfy heating Important Information Important Notice Unit Preparation Important Information Read Before OperatingPage Page Do not Connect to ANY AIR Distribution Duct or System Wood Pellets Setting the StirrerBurning Solid Fuels Flue System Be sure to check local codes in your areaOutside Air Outside Combustion Air Intake Mobile Home InstallationThrough the Ceiling Wall Protection Floor and Wall ProtectionFloor Protection START- UP Procedures Operating InstructionsTo remove the stirrer for burning pellets Corn START-UP ProcedurePellet START-UP Procedure SHUT-DOWN Procedure CodesDaily Operation Ash Pan Semi-Weekly Ash Removal Annual CleaningASH Removal and Disposal Maintenance Glass Auger Removal and ReplacementFinish Control Board Recommended Heat RangesCircuit Board Functions Component Operation Start Operation ENDAC-117, AC-117BN Lip Trim Accessory ItemsThermostat AC-118, AC-118BN Window TrimOptions Replacement PARTS, Accessories and OptionsCustomer Service Department Box Parts Orders only Monroe, VA Questions FaxCorn Stove Exploded View Diagram Illustration Adjusting your Hopper Lid Latch Dimensions of your corn/pellet unit Directions for Installation Legs or PedestalTROUBLE-SHOOTING Guide Problem Cause SolutionProblem Warranty is not Transferable Page Dealer Information Unit Information
Top Page Image Contents