England's Stove Works 10-CDV Circuit Board Functions, Component Operation Start Operation END

Illustration 5

CU-CB05

Control Board

Diagram (Wiring)

CIRCUIT BOARD FUNCTIONS

COMPONENT	OPERATION START	OPERATION END
Exhaust Blower	Starts Immediately	Will continue until shutdown.	Shutdown will
		occur when the operating temp. is below 90
		degrees.
Agitator	Three minutes after starting, the agitator	Will continue intermittently, as determined by the
	will begin to turn.	Heat Setting, until Shutdown
Auger	Three minutes after starting, the auger	The auger will continue at the feed rate
	will begin to turn.	determined by the Heat Setting.	NOTE: Safety
		switch, Hi Limit and Vacuum Sensor much be
		activated to continue proper operation.
Room Fan	Begins when 110 degrees is reached	Will continue to operate until the unit cools down
		to below 90 degrees. This may take from
		several minutes up to an hour.
Automatic	If, after 15 minutes, the unit has not	If the timer should expire before the preset
Shutdown	reached the preset operating temp., the	operating temp. is achieved, resetting the timer
	unit will begin to automatically shut	is possible by switching the Control Board “OFF”
	down. This will be evidenced by the red	and then back “ON.”
	light on the Control Board.
Normal Operation	If, after 15 minutes, the preset operating	Operation will continue until either the Control
	temp. of 110 degrees is achieved,	Board is turned “OFF,” or the operating temp.
	normal operation will continue.	falls to below 90 degrees. At this time, the unit
		will default to “Automatic Shutdown.”

21