Enviro 50-1096, C-10637 owner manual Third Stage Log Set Installation

Page 21

Secondary Installation

Figure 27: The front end of the right/center log has a notch in it that is to rest around the right/center post of the grate. The back end of the log rests on the burner tray (see Figure 26). Ensure the log does not block any burn ports.

Figure 27. Third Stage Log Set Installation.

Figure 28. Fourth Stage Log Set Installation.

Figure 29. Fifth Stage Log Set Installation.

Figure 28: Once the logs are in position the provided rock wool can be placed irregularly in front of the burner.

Figure 29: Place the embers irregularly onto and around the front of the burner to create a realistic look. The ceramic fiber comes in chunks that can be ripped into smaller pieces.

WARNINGS: DO NOT pack this ember material as this could create an unsafe condition. The pieces should be lightly placed so they don’t block any of the burner ports.

DO NOT allow any of the embers to rest against the pilot assembly.

Caution: Use only the type of ember material supplied with this fireplace. Due to the irregular size of the ember material, there may be more than required. Use of other foreign materials on the burners may create dangerous conditions.

21

Image 21
Contents What to do if YOU Smell GAS Safety Precautions For Your SafetyGeneral Table of Contents Vented GAS Fireplace Heater Sienna BV/DV NG/LPG Codes And ApprovalsSpecifications DimensionsRating Label Location 33 x 46 84cm x 193 cm Operating Instructions Pilot Lighting InstructionsPilot Light Burner Lighting Remote Controls OptionalTurn OFF Unit Blower SpeedCleaning the Glass Maintenance And ServiceCleaning the Firebox Cleaning the Plated SurfacesFuel Conversion To be Installed by a Qualified Service Agency onlyClearances to Combustibles Initial InstallationMinimum Fireplace Size Vent Model Automatic Flue GAS Spill Switch B-VENT Model onlyDirect Vent Model Preparing Your Sienna for InstallationVenting Fireplace Inserts Installation of Sienna DV and BVElectrical Requirements Prong from this plugGAS Line Connection Gas Line ConnectionConverting to a BV fireplace Converting a Direct Vent Fireplace to a B-VENT FireplaceReplacing the Blower Secondary InstallationDoor Removal Installation of Surround PanelEmpty firebox with grate and locator pins LOG SET and Ember InstallationThird Stage Log Set Installation Never operate the fireplace with the glass door removed Adjusting Venturi AIR SettingsRemoving the Brick Panel Brick panel set is fragile, handle with extreme careBV only Trouble ShootingNumber Parts List- Unit ComponentsComponentsDiagramParts Parts Diagram Burner Parts List Options Parts Diagram Options To the Dealer WarrantyInstallation Data Sheet