Enviro 50-1096 Brick panel set is fragile, handle with extreme care, Removing the Brick Panel

Secondary Installation

REMOVING THE BRICK PANEL:

The brick panel set is fragile, handle with extreme care.

The brick panel set comes pre-installed. The centre and top panel are the only panels that need to be removed if the complete gas and electrical tray assembly must be removed. The side panels may remain installed unless they are to be replaced.

1.Turn the unit off and allow the unit to cool completely.

2.Remove the fascia or louvers, open the door, and remove the log set.

3.Pull out the bottom of the centre panel while pushing up on the top panel.

4.With the center panel out, the top panel will easily come out. Just slide the top edge back out of the top lip in the firebox.

If the side panels must be removed, continue with steps 5, 6, and 7.

5.Remove the log support tray by lifting the back of the tray up and pull it out from under the lip. Take care not to knock the pilot and the side brick panels.

6.Remove the two (2) T-20 screws holding the bottom of the baffle (shown in Figure 33).

7.Pull the panels out of the lips at the front of the firebox and carefully remove the panel from the unit (shown in Figure 34).

To re-install, follow the above steps in reverse.

Figure 32: Brick Panel Installation.

Figure 33: Brick Panel Installation.

Figure 34: Brick Panel Installation.

23