Maintenance - Cleaning Glass on View Door
Fig. 34
Fig. 35
Fig. 36
WARNING
Door latch may
be hot!
Receiving Bolt
Opening and Closing the View Door
Opening:
The view door must be opened for cleaning of the glass and scraping of the burn pot. This should be done with the unit off and cool, in most cases. Although the glass can be cleaned and burn pot scraped while the unit is at low burn.
1.Using scraper as shown in Fig. 34and 35, lift the door latch forward and up.
2.Swing the door open to the left, stopping the swing when resistance is felt. Forcing the door open further then was designed may cause damage to the door or it's hinges.
CAUTION
Do not put excessive downward pressure on the latch end of the door while in the open position.
If the door is going to be opened for an extended period of time, it is suggested that it be removed (see Fig. 36) and set safely aside.
3.Inspect the door gasket and glass gaskets for worn or missing pieces. Replace if necessary. (Fig. 37)
Closing:
When closing the door, always hold the door latch all the way up until it has caught the receiving bolt. Then push the latch downward and back until the door is fully seated. See Fig. 35.
Removing View Door:
To remove the view door from the stove, hold the door by the bottom and lift upward off of the hinge pins.See Fig. 36.
Inspect the door gasket.See Fig. 37.
REPLACE GLASS WITH
CERAMIC GLASS ONLY.
Fig. 37
20