Removing Side Doors for Installation
Side
Door
Fig. 9
Side Door | Door |
| |
Magnets | Side |
|
Fig.10
Rear
Shield
Rear
Shield
Fig.11Fig.12
Rear Shield Retaining clip
Rear
Shield
Fig.13
Removing Side Doors
Figure 9
Use hand hole to swing open side doors to at least 90o.
Figure 10
Remove side doors by lifting upward on the door until the bottom pin is out of its hole. Move the bottom of the door out and away from the pedestal base about 1/2". Allow the door to slide downward until the top door pin is out of its top hole.
NOTE: Always remove the side doors and rear shields to move the unit. This will keep them from getting damaged.
Removing the Rear Motor Shield Sheet Metal.
NOTE: Disconnect power to the unit before removing the motor shields. Danger of electrical shock. Hot and moving parts could cause injury.
Figure 11
There are (2) #10 hex head screws holding each rear shield. Using a 5/16" nut driver or socket, loosen the
(2) screws about 4 or 5 turns.
Figure 12
Slide the rear shields straight outward until the ends come out of the rear retaining clips, as seen in Fig.13.
Placing Rear Shields Back on Unit
1.When replacing the shields, always insert the top and bottom ends of the sheet metal into the retaining clips first.
2.Slide the shields straight inward until the (2) hex head screws are fully inserted into the stove slots.
3.Make sure the top edges of the shield are against the hopper bottom and tighten screws.
Rear Shields are split around the Flue Tail pipe and outside Air Hole Knockout. This will allow removal and installation of the rear shields with the unit completely installed.
Skid Hold Down | Outside Air | 9 | |
Flex Hole | |||
Screws | |||
|
|
Knockout