Optimizing the suction force
In order to keep the suctionforce optimized, the filters mustbe cleared regularly during use.
• Turn the filter cleaning wheel (5) two turns clockwiseto remove any dust from the filters.
• The fine particulate filter must be cleaned regularly, see “Cleaning the fine particulate filter” section.
Cleaning and maintenance |
|
| |
Emptying the dust container |
|
| |
The dust container must be emptied regularly, preferably after every use. |
| ||
• | Pull the door latch (9) and open the transparent door (7) 180 degrees. |
| |
• | Tilt unit to empty dirt. |
|
|
• Tap the back end of unit if debris does not fall out easily or r emove filters for better | |||
access. |
|
| |
| WARNING:Do not, under any circumstances rinse out the dust | ||
container or immerse the appliance in water. A damp cloth and soapy water should be | |||
used to clean the exterior of the appliance. Always make sure that the appliance is | |||
completely dry before |
|
| |
Cleaning filters (figures E,F) | E |
| |
Both the plastic |
| 17 | |
pleated filter (18) are |
|
| |
be cleaned regularly. |
|
| |
• | Pull the door latch (9) and open the |
|
|
transparent door (7) 180 degrees. |
|
| |
• | Remove the |
|
|
appliance as shown in figure E. |
|
| |
• | Remove the pleated filter (18) by pulling |
|
|
firmly (figure F). |
|
| |
• | Tap the filters vigorously to remove loose |
|
|
dust. |
|
| |
• | If necessary, wash the filters in warm, |
|
|
soapy water. |
|
| |
• | Make sure that the filters are dry. |
|
|
• | Refit the pleated filter (18) into the dust |
|
|
container. |
|
| |
• | Refit the |
|
|
container. |
|
| |
• | Close the transparent door (7) and make | F |
|
sure that it clicks into place. |
| 18 |
6