Installing Logs on Models CGB3924PR and CGB3930PR

CGD3924PR, CGB3924PR and CGB3930PR

UNVENTED PROPANE/LP GAS LOG HEATER

INSTALLATION

Continued

INSTALLING LOGS ON MODELS CGB3924PR AND CGB3930PR

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

CAUTION: After installation and periodically thereafter, check to ensure that no flame comes in contact with any log. If so, repo- sition logs according to the log installation instructions in this manual. Flames contacting logs will create soot.

Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

Middle Log (#1)

Tab

Burner

“U” Bend

U-Shaped

Slot

Figure 22 - Installing Middle Log (#1)

1.Place the base of the middle log (#1) in the U-shaped slots of the grate base. The cutout on the right of the middle log should bit over the burner (see Fig- ure 22). Make sure the front of the middle log is resting on the tabs of the grate base and the cutout area is cen- tered over the burner “U” bend.

2.Locate pegs on the bottom of back log (#2). Slide these pegs into the holes in the grate base behind the burner (see Figure 23).

3.Place crossover log (#3) onto the pin (right) on middle log (#1) and into the recess of the back log (#2) (see Fig- ure 24).

Back Log (#2)

Hole in

Grate Base

Peg

Burner

Figure 23 - Installing Back Log (#2)

Crossover Log (#3)

Recess

Peg

4.Locate the notches in the bottom of the front log (#4). Place the front log on the grate fingers. Make sure the notches of the front log line up with the grate fingers (see Figure 25).

5.With knot to right side, place smaller log piece (#5) over the pin on the lift side of the middle log. The smaller log will rest on front log against the “knot” on the left (see Figure 26).

6.Add lava rock around base of heater. Do not place any lava rock on logs or burner.

Front Log (#4)

Notches

Grate Fingers

Figure 25 - Installing Front Log (#4)

Log Piece (#5)

Peg

Figure 26 - Installing Log Piece (#5)

Figure 24 - Installing Crossover Log (#3)

104307