Desa GMP26T, GMP20BT Specifications, GMP30BT GMP20BT, GMP16 GMP26 GMP16T GMP26T

Page 24

SPECIFICATIONS

	GMP30BT	GMP20BT
Btu (Variable)	15,000/30,000	10,000/20,000
Type Gas	Propane/LP Only	Propane/LP Only
Ignition	Piezo	Piezo
Pressure Regulator Setting	8" W.C.	8" W.C.
Inlet Gas Pressure (in. of water)
Maximum	14"	14"
Minimum	11"	11"
Dimensions, Inches (H x W x D)
Heater (Includes knobs & grill)	24 1/4 x 25 3/4 x 7	24 1/4 x 18 1/4 x 7
Carton	26 3/8 x 28 1/8 x 10	26 3/8 x 20 7/8 x 10
Weight (pounds)
Heater	28	20
Shipping	33	25

	GMP16	GMP26
	GMP16T	GMP26T
Btu (Variable)	6,000/11,000/16,000	6,000/16,000/26,000
Type Gas	Propane/LP Only	Propane/LP Only
Ignition	Piezo	Piezo
Pressure Regulator Setting	8" W.C.	8" W.C.
Inlet Gas Pressure* (in. of water)
Maximum	14"	14"
Minimum	11"	11"
Dimensions, Inches (H x W x D)
Heater	24 1/4 x 18 1/4 x 7	24 1/4 x 25 3/4 x 7
Carton	26 3/8 x 20 7/8 x 10	26 3/8 x 28 1/8 x 10
Weight (pounds)
Heater	20	28
Shipping	25	33

Note: Dimensions listed are outer most pointson the heater (includes control knobs and grill). * For purposes of input adjustment.

24

www.desatech.com

113048-01C

Image 24

Contents What to do if YOU Smell GAS Table of Contents Safety Information Safety Information Product Identification Local CodesAIR for Combustion Ventilation Providing Adequate VentilationUnusually Tight Construction Confined and Unconfined SpaceDetermining FRESH-AIR Flow for Heater Location Determining if You Have a Confined or Unconfined SpaceInstallation Ventilation AIRCheck GAS Type Ventilation Air From Inside BuildingInstallation Items Locating HeaterInstalling Heater to Wall 20,000 Btu/Hr Models Attaching To Wall Anchor MethodPlacing Heater On Mounting Bracket Installing Bottom Mounting Screws Mounting Base Feet to Floor Where required by local codeMounting Heater to Floor with Optional Floor KIT Mounting Base Feet to HeaterConnecting to GAS Supply Typical Inlet Pipe DiametersPressure Testing GAS Supply Piping System Checking GAS ConnectionsTest Pressures In Excess Of 1/2 Psig 3.5 kPa Test Pressures Equal To or Less Than 1/2 Psig 3.5 kPaFor Your Safety Read Before Lighting Pressure Testing Heater GAS ConnectionsOperating Heater Manual Control Models Lighting InstructionsManual Lighting Procedure To Select Heating Level for Infrared HeatersTo Turn OFF GAS To Appliance Thermostat Controlled Models Lighting Instructions Inspecting Heater Thermostat Control OperationPilot Flame Pattern Control Knob GMP16TInpecting Heater Burner Flame Pattern for Blue Flame HeatersBurner Flame Pattern for Infrared Heaters Cleaning Maintenance ODS/PILOT and BurnerBurner Pilot AIR Inlet CabinetTroubleshooting Observed Problem Possible Cause RemedyPressed See Cleaning and Mainte Gas leak. See Warning Statement aboveSpecifications GMP30BT GMP20BTGMP16 GMP26 GMP16T GMP26T Service Hints Technical ServiceService Publications Replacement Parts AccessoriesIllustrated Parts Breakdown Models GMP16, GMP26, GMP16T, and GMP26TParts List Parts AVAILABLE-NOT ShownIllustrated Parts Breakdown and Parts List Models GMP16 and GMP26ODS/Pilot Burner Assembly GMP16T Models GMP16T and GMP26TModels GMP20BT and GMP30BT Parts Available not Shown Warranty Information Keep this WarrantyLimited Warranty VENT-FREE Residential GAS Heaters