American Water Heater Residential Gas Water Heater with the Flame Guard Safety System, 319407-002

Page 33

REPAIR PARTS ILLUSTRATION

When ordering repair parts always give the following information:

1.Model, serial, and product number

2.Type of gas

3.Item number

4.Parts description

Repair Parts List

Item

Parts Description

No.

 

1DRAFT HOOD

2FLUE DAMPER

3FLUE BAFFLE

4HEAT TRAP (COLD) - SOME MODELS

5HEAT TRAP (HOT) - SOME MODELS

6COLD WATER DIP TUBE

7ANODE ROD

8TEMPERATURE & PRESSURE RELIEF VALVE (LOCATED ON SIDE)

9DRAIN VALVE

10GAS CONTROL VALVE/THERMOSTAT

11OUTER DOOR

12A*

STP (SPARK TO PILOT) PILOT ASSEMBLY KIT

12B*

STP (SPARK TO PILOT) PILOT ASSEMBLY KIT ( L.P.)

13A*

BURNER (Natural Gas/Low Nox)

13B*

BURNER (L.P.)

14A*

BURNER ASSEMBLY

14B*

BURNER ASSEMBLY ( L.P. Burner)

15*

MANIFOLD COMPONENT BLOCK

16*

MANIFOLD DOOR GASKET

17*

VIEWPORT ASSEMBLY

18**

TRANSFORMER ASSEMBLY KIT

19**

FV SENSOR KIT

20**

FV SENSOR KIT WITH BRACKET

21**

FV WIRE HARNESS

22**

MAIN WIRE HARNESS

23**

GAS CONTROL VALVE/THERMOSTAT CONTROL

 

MODULE

*Pictured on next page. ** Not shown.

1

5

4

2

6

3

8

18

7

10

12

13

9

11 14

LEGEND

Special anode rod (see page 21)

Temperature and Pressure Relief Valve is required, but may not be factory installed

Unique: Flame GuardSafety System parts

33

Image 33
Contents Flammable Vapor Ignition Resistant What to do if YOU Smell GASWater Heater Safety Consumer Information Important Information About This Water HeaterConsumer Responsibilities Unpacking the Water HeaterSite Location Location RequirementsInspection and service Clearances and AccessibilityGas Supply Gas RequirementsGas Pressure Combustion Air Supply and Ventilation Unconfined Space Confined SpaceAll Air from Inside the Building Louvers and Grilles All Air from OutdoorsVent Connectors Draft Hood InstallationVent Pipe System Vent Pipe SizeVertical Exhaust Gas Vent Chimney ConnectionWater System Piping Piping InstallationClosed System/Thermal Expansion Relief Valve and Pipe Insulation Some Models Temperature and Pressure Relief ValveSolar Installation Special ApplicationsCombination Space Heating/Potable Water System Installation Checklist Explosion Hazard Lighting InstructionsG. Bottled Propane Models Water Temperature StackingChecking the Draft Burner Flames154 Instantaneous Second Water Temperature RegulationElectrical Connections Wiring DiagramWater Temperature Adjustment Operating the Temperature Control SystemOperating Modes and Settings Status Light CodeOperational Conditions Draining and Flushing Routine Preventative MaintenanceRemoving the Burner from the Manifold Assembly Replacement PartsRemoving the Manifold Assembly Replacing the Pilot/Igniter Flame Sensor AssemblyFilter Installation and Cleaning Cleaning the Combustion Chamber and Flame-trap External Inspection & Cleaning of the Flame-trapIgniter System Replacing the Manifold AssemblyRemoving and Replacing the Gas Control Valve/Thermostat Flame Guard Safety System Operational ChecklistBurner Flame Yellow Status Light Code Troubleshooting Table Status Light Code Troubleshooting Table Sequence of Operation Chart Repair Parts List Repair Parts IllustrationListed Parts Kits and Illustrations