GTO 352 installation manual Control Board Connections, 18 VAC, Solar Panel +

Control Board Connections

LOCK OUTPUTS

1AUX OUT (+): (Typically for use with automatic gate lock or light)

•Provides 12Vdc power @ a maximum of 2 Amps or less than 25 watts when the gate is in motion.

2AUX OUT (-):(Typically for use with automatic gate lock or light)

•Provides 12Vdc power @ a maximum of 2 Amps or less than 25 watts when the gate is in motion.

NOTE:

•All control inputs are dry-contact, normally open, inputs. DO NOT apply external voltage sources to these inputs.

•All inputs are connected with respect to COMMON terminal.

•The status light will blink once when its corresponding input is activated.

INPUTS		• Input for 18-22Vdc charge power from solar panel	1
	3	SOLAR PANEL (-)
POWER	4	18 VAC	2
CHARGE		• Input for 18-22Vac charge power from transformer	3
	5	SOLAR PANEL (+):	4
		• Input for 18-22Vdc charge power from solar panel	5
		• Input for 18-22Vac charge power from transformer.

6EXIT: (Typically for use with exit loop or wand)

•Activation of this input will open the gate if it’s not already at the open position

•Activation of this input while at open limit will restart the auto close time (if enabled).

	7	SAFETY: (Typically for use with photo beam device, loop	6
			7
		detector or other non-contact sensors)
		• Activation of this input while the gate is closing will cause	8
		the gate to stop and return to the opened position.	9
INPUTS		• Activation of this input while the gate is opening has no effect
		(gate will continue to open).	10
		• Activation of this input while gate is idle will prevent gate from
ACCESSORY		closing.
	8	EDGE: (Typically for use with safety edge device or other
		contact sensor)
		• Activation of this input while the gate is operating will cause the
		gate to stop and reverse direction for approximately 2 seconds.
		• Activation of this input while gate is idle will prevent gate
		from opening or closing.
	9	CYCLE: (Typically for use with doorbell button or hardwired keypad)
		• Each activation at this input will cycle the operation as follows:
		….→ OPEN → STOP → CLOSE → STOP → OPEN → …

10COM: Circuit common (reference for all logic input)

• Two (2) terminals to provide extra common connection point.

AUX OUT
SOLAR PANEL	18VAC

LINK

EXIT

SAFETY

EDGE

CYCLE

COMMON

RCVR	GRN
	BLK
	RED

32 M i g h t y M u l e 3 5 2