Genie 4024H manual Opener Features, Safety Features

Page 3

OPENER FEATURES

INTELLICODE® 2 Access Security System

A new generation superior encryption system that enhances the security of the door opener by continuously changing the access code each time the remote is used. The door opener responds to each new code only once. An access code copied from a working system and tried again will not control the door opener.

Wall Console, Series III

Operates door opener from inside garage. The Wall Console has an Indicator Light with: Open/Close, Sure-Lock™, and Independent Light Control buttons.

and Car2U® compatible. Refer to the programming instructions on page 10 and then follow the HomeLink® or Car2U® instructions in your car owner’s manual.

SAFETY FEATURES

Safe-T-Beam® (STB) Non-Contact Reversing System

Puts an invisible beam across the door opening. The door stops and reverses to the full open position if anything passes through the beam. LED indicator lights on the powerhead and on the STBs provide a self diagnostic code if an operational problem exists.

Safe-T-Reverse® Contact Reversing System

Automatically stops and reverses a closing door within two seconds of contact with an object.

Automatic ForceGuard™ Control

Automatically sets the force required to fully open and close the door for maximum safety.

Watch Dog™ Monitoring System

Monitors the Safe-T-Beam® system to ensure proper functionality and will automatically stop and reverse a closing door if a problem is detected.

Manual Emergency Release

Manually releases door from door opener. Used during a power failure or other emergency to allow manual opening and closing of door.

SmartSet™ Electronic Programming

Easily adjust the programming to reduce opening speed to a desired rate, vary limits and force, and program new remotes.

Automatic Lighting System

Two bulb lighting system supplies up to 200 Watts of light for safer evening exits and entries. Turns ON when door is activated and automatically turns OFF 4 minutes later.

Integrated Motion Detection (Not available on all models)

Select units have motion detection built into the powerhead. Lights automatically turn ON when motion is detected for much safer movement through the garage. Lights will turn OFF after 4 minutes of no motion.

©2010 The Genie Company

12/2010

3

Image 3
Contents Operation and Maintenance Manual Prevention Potential HazardSafety Features Opener FeaturesTable of Contents Infrared Protection Function Important Installation InstructionsClose Door Travel Limit Programming Limits & ForceBoth LEDs flash Blue Go OFF Open Door Travel LimitSee long Blue LED flashing Door Limits are setTest AdjustmentSee round Blue LED come on Bring remotes to powerhead locationSee long Purple LED flashing IntelliCode 1 remotesSee long Purple LED flashing + see both LEDs Flash Purple Genie IntelliCode 1 wireless keypadGenie IntelliCode 1 remote See onePower Head Tête DE Puissance Cabeza DE LA Energía Reference Powerhead & Rail Assembled ViewInstallation Typique SUR UNE Porte Sectionelle Typical ONE Piece Door Installation Overview of Powerhead Controls On powerheadProgramming Buttons location Hold Overview Remotes and OptionsIntellicode Features Transmitter Compliance Statement Maintenance & TroubleshootingDoor Balance Spring Tension Routine Monthly MaintenanceAdjustment Safe-T-Beam System Check Door balance Contact reverseMotion DETECTOR* Overview Reset OPEN/CLOSE Travel LimitDoor Change Light BulbsClosed Unlock allows controls to work normally Wire routingWall Console Overview Open and closes door from inside garageChain Chain or Belt Tension AdjustmentRemote Battery Replacement BeltAdjustment Guide Speed Settings Change Speed SettingPowerhead LEDs Round LED Long LED Change Force Setting Adjustment Guide Force SettingsTroubleshooting Guide Operation Powerhead LED Possible Problem Solution Opening Cover May Cause Electric Shock Reference Circuit Wiring DiagramLimited Warranty