Genie 2042, 2022, 2024 manual Opener Installation Header and Door Mounting Brackets, Extend, Final

2OPENER INSTALLATION

HEADER AND DOOR

MOUNTING BRACKETS:

WARNING

Header bracket must be fastened to garage framing. Do NOT fasten to drywall, particle board, plaster or other such materials.

1.Finding header bracket mounting location.

•Close garage door.

–Use a pencil and level.

a)Mark center of garage door (one-half overall width) on the wall with 6" vertical line at top edge of door.

b)Continue this line on wall above door for about 12" (Fig. 2-1, a).

•Raise garage door until top edge of door reaches its maximum height (Fig. 2-2).

•With door at highest point.

–Measure height from top edge of door to floor

(Fig. 2-2).

•Close door again.

•Mark height measurement on wall above door

(Fig. 2-1, c).

–Make your mark across vertical line made earlier.

•Add 2-1/2" to height mark just made on wall. This is location for header bracket (Fig. 2-1, d).

WARNING

Door springs are under high tension. If spring or its shaft is in the way, measure 2-1/2" above spring or shaft on the garage door centerline and mark this height as your location for header bracket.

Do NOT move door spring!

NOTE: If header bracket location needs to be above header for garage door opening, you need to add a "mounting surface." A 2" x 6" board securely attached (board and fasteners not included) to wall studs on either side of your mark is sufficient (Fig. 2-3).

NOTE: For header bracket and bolts locate Bag 2 from Box 1.

NOTE: The bolts supplied in Bag 2 are designed to be used on pressure treated lumber.

2.Mounting the header bracket.

•Hold header bracket against wall (Fig. 2-3).

•Position bracket as shown.

–Place center on vertical line,

–Bottom edge on final height line.

•Mark screw hole locations on wall.

•Drill 3/16" pilot holes at each screw hole mark.

–Fasten header bracket with 2 lag screws (provided) (Fig. 2-3).

FOR HELP-1.800.354.3643 OR WWW.GENIECOMPANY.COM

b) - extend

vertical line

2-1/2"

	d) - final
c) - door at
	height mark
highest point

	top of door
	in closed
		a) - 6" vertical
	position	line
FIG. 2-1 Final height mark.

HIGHEST POINT OF TRAVEL

2-1/2"

HEADER

TRACK

SECTIONAL	HEADER
DOOR		HIGHEST POINT OF TRAVEL
		TRACK
FROM HERE	SECTIONAL	FROM HERE
TO FLOOR
	DOOR	TO FLOOR

FIG. 2-2 Finding highest point of travel.

final	height				final	height
		mark			mark
	2-
	1/2"
	door at		highest		door at		highest	point
				point

FIG. 2-3 Header bracket mounting (on header & above header).

12 PN# 37026500123 02/26/2010 REV. 1