Allstar Products Group AC9500, AC9300, ACJ9500 Installation of Radio Controls, Transmitter

D: CONTROL AND AUXILIARY EQUIPMENT

INSTALLATION OF RADIO CONTROLS:

The following instructions detail installation of Model 9931 Radio Controls. For other Radio models, see instructions packaged with product.

TRANSMITTER:

To	gain	access	to
the	Transmitter
Coding		Switches,
remove		the Battery
Cover		from	the
fr o nt		o f	t he
Transmitter			by

sliding it toward the bottom of the Transmitter as illustrated.

104384

RECEIVER: The Receiver Coding Switches can be accessed by removing the small door from the back of the

Receiver using a small screwdriver or knife.

104385

Setting The Coding Switches: When setting the Coding Switches THE FACTORY PRE-SET CODES MUST BE CHANGED TO PREVENT UNAUTHORIZED OPERATION. Transmitter and Receiver codes must be set IDENTICALLY. If just one Code Switch is mismatched, the Radio Controls will not function.

NOTE: For security reasons, it is advisable NOT to set all the switches in the same position.

Mounting The Receiver: After setting the Coding Switches, mount the Receiver on the rear panel of the Opener by connecting it to Terminals 1, 2 and 3. For proper operation, the Antenna Wire should be POINTED STRAIGHT DOWN toward the floor.

			After		installing		the		Radio
			Controls, check their					operation
			by	moving		approximately				35
			FT away from the garage door
			and	pressing		the	Transmitter
			Button.		Operation			at		this
			distance should be reliable.
			If	the	Transmitter				doesn't
			activate		door	operation,			check
POINT ANTENNA			that all Coding Switches are set
			identically.			If the	operational
STRAIGHT DOWN	108386		distance		is	inadequate,				try
			moving the position of the
Transmitter in the car. If the distance is still		inadequate, try bending the Antenna Wire
to a different angle.	If the distance is	still

inadequate, replace the Battery with a standard 9-	104388
Volt “transistor radio” Battery (NEED 1604). The
Battery is located in the front compartment next to
the Coding Switches.
The Transmitter may be hand held if desired by
removing the Visor Clip from the rear of the Case
as illustrated. Place your finger in the loop at the
top of the visor, and your thumb on the top edge
of the Transmitter. Push down with your thumb
and pull up with your finger. The clip will release
and pull out easily.

104386

CODING BLOCK: Transmitter and Receiver Coding Switches are contained in identical Coding Blocks, consisting of nine small switches, labeled 1 - 9, each of which can be set in any of three positions, labeled +, 0, -

WARNING

TO PREVENT THE RISK OF PERSONAL INJURY, DAMAGE TO DOOR OR PROPERTY, ONLY OPERATE DOOR CONTROLS WHEN DOOR IS IN CLEAR VIEW. KEEP REMOTE CONTROL AWAY FROM CHILDREN IN SECURE AREA.

14