Hitachi 236464 manual Symbols, Equipment Misuse Hazard

Page 3

Symbols

Warning Symbol

WARNING

This symbol alerts you to the possibility of serious injury or death if you do not follow the instructions.

Caution Symbol

CAUTION

This symbol alerts you to the possibility of damage to or destruction of equipment if you do not follow the instructions.

WARNING

INSTRUCTIONS

EQUIPMENT MISUSE HAZARD

Equipment misuse can cause the equipment to rupture or malfunction and result in serious injury.

DThis equipment is for professional use only.

DRead all instruction manuals, tags, and labels before operating the equipment.

DUse the equipment only for its intended purpose. If you are uncertain about usage, call your Graco distributor.

DDo not alter or modify this equipment. Use only genuine Graco parts and accessories.

DCheck equipment daily. Repair or replace worn or damaged parts immediately.

DDo not exceed the maximum working pressure of the lowest rated system component. Refer to the Technical Data on page 25 for the maximum working pressure of this equipment.

DUse fluids and solvents which are compatible with the equipment wetted parts. Refer to the Tech- nical Data section of all equipment manuals. Read the fluid and solvent manufacturer’s warnings.

DDo not use hoses to pull equipment.

DRoute hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not expose Graco hoses to temperatures above 82_C (180_F) or below –40_C (–40_F).

DWear hearing protection when operating this equipment.

DDo not lift pressurized equipment.

DComply with all applicable local, state, and national fire, electrical, and safety regulations.

308350 3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents
Dura-Flot600 Pumps Instructions Parts ListList of Models Table of ContentsEquipment Misuse Hazard SymbolsMoving Parts Hazard Injection HazardToxic Fluid Hazard Fire and Explosion Hazard308350 Object being sprayed follow your local code InstallationSystem Accessories General Information GroundingAir Line Accessories KEY Typical Installation110 Operation/MaintenancePressure Relief Procedure Packing Nut/Wet-CupFlush the Pump Before First Use Starting and Adjusting the PumpFlushing Shutdown and Care of the PumpTroubleshooting Chart Its stroke keep the wet-cup 1/3 filled with aCompatible solvent Required Tools ServiceDisconnecting the Displacement Pump Reconnecting the Displacement Pump107 106 110 109 101 105 108Disassembly Displacement Pump ServiceTorque to 258-285 NSm 190-210 ft-lb Reassembly 10 Ref 11 Ref Using a pipe wrench, torque the intake housing Install the seal 11* on the bottomHousing 7 onto the cylinder handtight. Sealing surface of the intake housingParts 101 105 108 109 102Y 107 106 110102Y 107 106 110 113 Part No Pump, Series a 251 Ratio, with Senator Air Motor101 105 108 109 102Y 107 110 106 112Piston Packing Stack See Throat Packing Stack seeUHMWPE/PTFErPacking Kit 237609 Optional Packing KitsTeflonr Packing Kit 237236 Optional UHMWPE/Leather Packing Kit 237238 OptionalTested in accordance with ISO Technical DataLiters/min 11.4 Mounting Hole Layout DimensionsGraco Information Graco Standard Warranty
Top Page Image Contents