Hitachi 236464 manual Fire and Explosion Hazard, Toxic Fluid Hazard

Page 5

WARNING

FIRE AND EXPLOSION HAZARD

Improper grounding, poor ventilation, open flames or sparks can cause a hazardous condition and result in a fire or explosion and serious injury.

DGround the equipment and the object being sprayed. Refer to Grounding on page 7.

DIf there is any static sparking or you feel an electric shock while using this equipment, stop spray- ing immediately. Do not use the equipment until you identify and correct the problem.

DProvide fresh air ventilation to avoid the buildup of flammable fumes from solvents or the fluid being sprayed.

DKeep the spray area free of debris, including solvent, rags, and gasoline.

DElectrically disconnect all equipment in the spray area.

DExtinguish all open flames or pilot lights in the spray area.

DDo not smoke in the spray area.

DDo not turn on or off any light switch in the spray area while operating or if fumes are present.

DDo not operate a gasoline engine in the spray area.

TOXIC FLUID HAZARD

Hazardous fluid or toxic fumes can cause serious injury or death if splashed in the eyes or on the skin, inhaled, or swallowed.

DKnow the specific hazards of the fluid you are using.

DStore hazardous fluid in an approved container. Dispose of hazardous fluid according to all local, state and national guidelines.

DAlways wear protective eyewear, gloves, clothing and respirator as recommended by the fluid and solvent manufacturer.

308350 5

Image 5 Contents
Dura-Flot600 Pumps Instructions Parts ListList of Models Table of ContentsEquipment Misuse Hazard SymbolsMoving Parts Hazard Injection HazardToxic Fluid Hazard Fire and Explosion Hazard308350 System Accessories InstallationGeneral Information Grounding Object being sprayed follow your local codeAir Line Accessories KEY Typical InstallationPressure Relief Procedure Operation/MaintenancePacking Nut/Wet-Cup 110Flush the Pump Before First Use Starting and Adjusting the PumpFlushing Shutdown and Care of the PumpCompatible solvent Troubleshooting ChartIts stroke keep the wet-cup 1/3 filled with a Disconnecting the Displacement Pump ServiceReconnecting the Displacement Pump Required Tools107 106 110 109 101 105 108Disassembly Displacement Pump ServiceTorque to 258-285 NSm 190-210 ft-lb Reassembly 10 Ref 11 Ref Housing 7 onto the cylinder handtight. Install the seal 11* on the bottomSealing surface of the intake housing Using a pipe wrench, torque the intake housing102Y 107 106 110 Parts101 105 108 109 102Y 107 106 110 101 105 108 109 Part No Pump, Series a 251 Ratio, with Senator Air Motor102Y 107 110 106 112 113Piston Packing Stack See Throat Packing Stack seeTeflonr Packing Kit 237236 Optional Packing KitsUHMWPE/Leather Packing Kit 237238 Optional UHMWPE/PTFErPacking Kit 237609 OptionalTested in accordance with ISO Technical DataLiters/min 11.4 Mounting Hole Layout DimensionsGraco Information Graco Standard Warranty