GE Monogram GXSF18G Sanitizing Procedures, Specifications/Dimensions, 30″

Page 13

Installation Instructions

SANITIZING PROCEDURES

To complete the installation, do the following sanitizing procedures.

Care is taken at the factory to keep your water softener clean and sanitary. Materials used to make the softener will not infect or contaminate your water supply and will not cause bacteria to form or grow. However, during shipping, storage, installation and operation, bacteria could get into the softener. For this reason, sanitizing as follows is suggested when installing.

NOTE: Sanitizing is recommended by the Water Quality Association for disinfecting.

1.Be sure to complete all installation steps, including programming the control.

2.Pour about 3/4 oz. (11⁄2 tablespoons) of common 5.25% unscented household bleach (Clorox, Linco, Bo Peep, White Sail, Eagle, etc.) into the brinewell. Refer to illustration on page 5.

3.IMPORTANT: Press and hold for 3 seconds the faceplate RECHARGE button to start an immediate recharge. RECHARGE begins to flash in the display. The bleach will be drawn through the

water softener, and out the drain. This process takes approximately 2 hours.

4.If, after sanitization, water from the house faucet tastes salty or has a slight color, this is a preservative from the resin tank. Turn on the cold soft water faucets and drain for a few minutes or until clear.

NOTE: When the sanitizing recharge is over, all remaining bleach is flushed from the conditioner and your house COLD water supply is fully soft immediately. However, your water heater is filled with hard water and as hot water is used, it will refill with soft water. When all the hard water is replaced in the water heater, hot only and mixed hot and cold water will be fully soft. If you want totally soft water immediately, after the above recharge, drain the water heater until the water runs cold.

WARNING: If you do drain the water heater, use extreme care as the hot water could cause burns. Turn the water heater off prior to draining.

SPECIFICATIONS/DIMENSIONS

 

GXSF18G

 

 

 

 

 

 

 

 

Rated Capacity*

8,000 grains with 1.8 lbs. of salt

 

 

 

 

13,300 grains with 3.8 lbs. of salt

 

 

 

 

18,800 grains with 10.2 lbs. of salt

 

 

 

 

 

 

 

 

Rated Efficiency**

4,330 grains/lb. @ 1.8 lbs. of salt

 

 

 

 

 

 

 

 

Amount of High Capacity Resin (lbs/cu. ft)

33.3/0.64

 

 

 

 

 

 

 

 

 

 

 

Resin Tank Nominal Size (in., dia. x height)

10 x 21

 

 

 

 

 

 

 

 

Service Flow Rate (gpm)

7

 

 

 

 

 

 

 

 

Water Supply Maximum Hardness (gpg)

95

 

 

 

 

 

 

 

 

Water Supply Maximum Clear Water Iron (ppm)***

5

 

 

 

 

 

 

 

 

Water Pressure Limits (min.–max. psi)****

20–125

 

 

 

 

30″

Pressure Drop at Rated Service Flow (psig)

8

 

 

 

 

 

 

 

 

Water Temperature Limits (min.–max. °F)

40–120

 

 

 

 

 

 

 

 

Maximum Flow Rate to Drain (gpm)

2.2

 

 

 

 

 

 

 

 

This system conforms to NSF/ANSI 44 for the specific capacity claims as verified and substantiated by test data.

*Testing was performed using pellet grade sodium chloride as the regenerant salt.

**Efficiency rating is valid only at the lowest stated salt dosage and service flow rate. This softener was efficiency rated according to NSF/ANSI 44.

***Extent of iron removal may vary with conditions. The capacity to reduce clear water iron is substantiated by independent laboratory test data. Use of Diamond Crystal® Red•Out® or Super Iron Out® will improve iron removal. Refer to Cleaning Iron Out of the Water Softening System section.

****Canada working pressure limits: 1.4–7.0 kg/cm2.

33⁄8″

Outlet Inlet

22.9″

14.5″

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Care and Cleaning Safety Information7289396 215C1173P027 49-5018207-06 JR Write the model and serial numbers here Model #Safety Precautions Important Installation Recommendations Before Beginning InstallationRead these instructions completely and carefully Unpacking and Inspection Where to Install the SoftenerTransit OUT Plan HOW YOU will Install the SoftenerBefore YOU Begin Install Bypass ValveAdapter Valve body Bypass valve Inlet or outletPlumb in and OUT Pipes to and from Softener Connect and RUN the Valve Drain HoseDrain Hose Tie or wire Hose in place Connecting a Rigid Valve Drain TubeFittings On valve Valve 11⁄2″ air gapADD Water and Salt to the Brine Tank Install Grounding ClampWith salt Programming the Control Connect to Electrical PowerSET Present Time of DAY SET Water Hardness NumberSET Recharge Starting Time SET Salt LevelDays to Empty Signals Optional Control SettingsSPECIFICATIONS/DIMENSIONS Sanitizing Procedures30″ 33⁄8″ Outlet Inlet 22.9″ 14.5″About the water softener system Breaking a Salt Bridge Cleaning the Nozzle and Venturi AssemblyGe.com Feature Memory Feature Optional Recharge ControlsFeature/Service Automatic Electronic Diagnostics Normal Operation, Control DisplaysTo remove an error code 1. Unplug transformer Service Timer/Softener, Service Checkout ProcedureERR Operation of Diagnostics Service Set Model CodeIf the water softening system does not draw brine, check Cleaning Iron Out of the Water Softening System Care and cleaning of the water softening systemChecking the Salt Storage Level and Refilling However, you must keep the tank supplied with saltWhat To Do Before you call for service…No soft water Taken not plumbed to soft waterWater in brine tank Excessive/high levelSalty tasting or Brown/yellow colored Water after installationBrown/yellow Colored water Resin beads showingPage Ge.com Page Parts list Parts list General Electric Parts Catalog Parts catalogSupport Screen For The Period We Will Replace What Is Not CoveredWarrantor General Electric Company. Louisville, KY For The Period Of We Will Replace GE Water Softening System Warranty. For Customers in CanadaWarrantor Mabe Canada INC One YearDe agua Cuidado y limpieza Cómo limpiar la ensambladuraDe averías Advertencia No use con agua AdvertenciaLea estas instrucciones completa y cuidadosamente Recomendaciones Importantes Para LA InstalaciónDonde Instalar EL Descalcificador Desempacado E InspecciónHerramientas Y Materiales Necesarios Para LA Instalación Use la válvula de bypass incluida para instalarIlustración DE Instalación Normal Planifique LA Instalación DEL DescalcificadorInstale LA Válvula DE Bypass Antes DE ComenzarRemueva el tapón plástico de embalaje y el cable de la Cerciórese de cumplir con los códigos locales Retire el descalcificador del lugar de instalaciónCont Salmuera Y LA MangueraCómo Conectar UN Tubo DE Drenaje DE Válvula Rígida Cierre todos los grifos de agua Instale LA Abrazadera DE TierraProgramación DEL Control Conectar a LA Fuente EléctricaAjuste LA Hora DEL DÍA Hora actualDías Hasta Vacío Ajuste EL Nivel DE SALDe recarga De salEficiencia DE LA SAL Ajustes Opcionales DE ControlSeñals En la fábrica se siguen los cuidados para mantener Procedimientos DE DesinfecciónNi infectarán su suministro de agua ni causarán que Sobre el sistema de descalcificación de agua Cómo romper un puente de sal Cómo limpiar la ensambladura de la boquilla y el Venturi Función Controles opcionales de recargado Operación normal, Pantalla de controlFunción Memoria Característica/Servicio Diagnóstico electrónico automáticoVisualizado Vea la sección Programación del control Servicio Diagnóstico electrónico iniciado manualmenteServicio Inspección manual del avance de la recarga Servicio Configurar el código del modeloCuándo rellenar con sal Si una luz indicadora Cuidado y limpieza del sistema de descalcificación de aguaQué hacer Antes de llamar para solicitar servicio…Veces el agua Luz intermitente azul Notas Lista de partes Ge.com Catálogo DE Partes DE General Electric Catálogo de partesPASADOR, Expansión Por el período de Reemplazamos Garantía GE para el Sistema de Descalcificación de AguaLo que no está cubierto Solicite una reparación Soporte al Consumidor Página Web de GE AppliancesGarantías ampliadas Piezas y accesoriosParts and Accessories Schedule ServiceConsumer Support GE Appliances Website Real Life Design Studio

GXSF18G specifications

The GE Monogram GXSF18G is a premium side-by-side refrigerator that combines sophisticated design with cutting-edge technology. This model is designed to meet the needs of modern households, blending style, functionality, and energy efficiency. It stands out with its sleek stainless steel finish and a professional look that elevates any kitchen decor.

One of the primary features of the GE Monogram GXSF18G is its spacious interior. With an impressive capacity, this refrigerator offers ample storage options for all your food items. The adjustable shelves allow for customization of the space, accommodating tall bottles or large containers with ease. The clear drawers provide easy visibility, ensuring that you can quickly find what you need without rummaging through the fridge.

The GXSF18G includes advanced cooling technologies that help maintain optimal temperature and humidity levels for food preservation. Its dual climate control system ensures separate temperature zones for the refrigerator and freezer. This innovation not only keeps your food fresher for longer but also helps reduce energy consumption, thus improving efficiency.

Another standout feature is the energy-efficient LED lighting, which illuminates the interior while consuming less power than traditional bulbs. This feature enhances visibility, making it easier to see everything inside and find items quickly, even in low light conditions.

The water and ice dispensing system is also noteworthy. It provides easy access to clean drinking water and ice without opening the refrigerator door, minimizing temperature fluctuations and maintaining freshness. The water filtration system is designed to reduce contaminants, ensuring you have access to pure, refreshing water.

Furthermore, the GE Monogram GXSF18G is equipped with smart technology, allowing you to monitor and manage settings right from your smartphone. This tech-savvy feature offers convenience for busy individuals, making it simple to keep track of your refrigerator's performance and any alerts that may arise.

In conclusion, the GE Monogram GXSF18G is a top-tier refrigerator that combines style, efficiency, and advanced technology. With its spacious interior, innovative cooling solutions, energy-saving features, and smart connectivity, it is an excellent choice for those looking to enhance their kitchen with a premium appliance that doesn't compromise on performance or design. Investing in this refrigerator means investing in quality and convenience for your home.
Top Page Image Contents